Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS501221
$262.99
(You save)
Restore precise wheel location and quiet suspension travel with the Mevotech Supreme Suspension Control Arm and Ball Joint Assembly (CMS501221). This rear right lower assembly is a direct-fit replacement for the 2010-2016 Cadillac SRX, combining the control arm and its ball joint into one pre-assembled unit.
Integrated ball joint: the control arm and its ball joint arrive as a single assembly, so you address both wear points in one installation.
Direct-fit replacement: supplied for the listed Cadillac SRX applications in the rear right lower position.
Locates the wheel: the arm positions and guides the rear right lower suspension while the ball joint allows the required range of motion.
Signs this assembly may need replacing include clunking over bumps, uneven or inner-edge tire wear, and loose or wandering steering feel. These symptoms can have other causes, so diagnose the source before replacing. If a worn control arm or ball joint on this corner is the cause, this unit replaces it. Sold individually as one rear right lower assembly; inspect the opposite side and replace as directed by the service procedure.
Interchange: 19457077 · 15853187 · GS501221 · 2608735 · 12CB50633. Manufacturer part number CMS501221.
This part cross-references / interchanges with the following part numbers:
It is the rear right lower control arm and ball joint assembly for the listed Cadillac SRX applications.
Which vehicles does CMS501221 fit?
It is a direct-fit replacement for the 2010-2016 Cadillac SRX. Check the Buyer's Guide tab to confirm your exact vehicle.
What numbers does this part interchange with?
It replaces 19457077, 15853187, GS501221, 2608735 and 12CB50633.
What are signs I may need to replace it?
Clunking over bumps, uneven or inner-edge tire wear, and loose or wandering steering can indicate a worn control arm or ball joint. Diagnose the cause before replacing.
Does it include the ball joint?
Yes. The ball joint comes pre-installed in the assembly, so you replace the arm and joint together as one unit.
Write a Review
MEVOTECH
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS501221
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
Keep the front wheel precisely located and steering response tight with the Mevotech Supreme Suspension Control Arm and Ball Joint Assembly (CMK80349). This front left lower unit combines the control...
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
