Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS501222
$262.99
(You save)
Restore precise rear suspension geometry with the Mevotech Supreme control arm, part number CMS501222. This rear left lower control arm and ball joint assembly is a direct-fit replacement for the 2010-2016 Cadillac SRX, arriving with the ball joint and bushing pre-assembled so you install one complete unit. Mevotech Supreme parts are engineered in-house with application-specific upgrades and Labor Saver designs that make the job faster.
Faster installation: ships with the ball joint and bushing pre-assembled as a complete solution, plus a part-specific locking nut to speed up the ball joint fit.
Superior toughness: patented sintered bearings for longer-lasting performance.
Longer service life: additional surface treatment on the ball joint helps prevent rust build-up, and the joint uses a thicker, stronger flange to resist deformation during installation.
Increased stiffness: bushings upgraded with a solid cross section for improved handling and durability, plus an included 90-degree SAE grease fitting for simple servicing.
Meets or exceeds OE specifications with cast aluminium construction. If a worn control arm bushing or ball joint is behind clunking over bumps, wandering steering, or uneven tire wear, this Mevotech Supreme lower control arm replaces it.
What vehicles does this Mevotech Supreme suspension control arm fit?
It is a direct-fit replacement for the 2010-2016 Cadillac SRX. Check the Buyer's Guide tab to confirm it matches your exact vehicle and engine.
What position on the vehicle is this control arm for?
This is the rear left (driver's side) lower control arm with its integrated ball joint. Confirm it matches the corner you are servicing before ordering.
Does it come with the ball joint and grease fitting?
Yes. The ball joint and bushing are pre-assembled into the arm, and it includes a 90-degree SAE grease fitting plus a part-specific locking nut.
What is this control arm made of?
It uses cast aluminium construction that Mevotech states meets or exceeds OE specifications, with patented sintered bearings and a solid cross-section bushing for added stiffness.
What are signs my control arm may need replacing?
Clunking over bumps, wandering or loose steering, and uneven tire wear can point to a worn bushing or ball joint. Diagnose the cause first, then replace as needed.
Write a Review
Mevotech Supreme
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS501222
Help keep your front wheel located and your steering tight with the Mevotech Supreme control arm CMS101427, a front left lower unit that drops in as a direct-fit replacement for the listed...
Help keep your steering tight and your wheel located precisely with the Mevotech Supreme Suspension Control Arm and Ball Joint Assembly (CMS861335), a direct-fit front right lower unit for the listed...
Tighten up a loose, clunking front end with the Mevotech Supreme control arm, part number CMS501370. This is the front right upper control arm and ball joint assembly, pre-loaded with an integrated...
Keep your rear suspension properly located and take up worn play with the Mevotech Supreme control arm (CMS801038), a direct-fit replacement for the 2006-2013 Suzuki Grand Vitara. This is the rear...
Keep your front suspension tracking straight with the Mevotech Supreme control arm CMS76124, a front left lower control arm and ball joint assembly that installs as a direct-fit replacement for the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
