Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS7508
$76.99
(You save)
Restore tight, controlled front suspension geometry with the Mevotech Supreme control arm CMS7508, a front left lower unit that drops in as a direct-fit replacement for the 1993-1997 Ford Probe, 1993-1997 Mazda 626 and 1993-1997 Mazda MX-6. This Mevotech Supreme lower control arm locates the wheel and pivots the suspension through travel, while its integrated ball joint allows the knuckle to steer and articulate. If a worn arm or ball joint is behind clunking over bumps, wandering steering or uneven tire wear, replacing it addresses that source.
The Mevotech Supreme suspension control arm ships as a one-piece assembly engineered in-house with application-specific upgrades:
Fasteners included: an application-specific pinch bolt and locking nut are provided to install the ball joint faster.
Stamped steel construction: built to OE-level tolerances for durability.
Resists corrosion: a protective surface treatment helps guard against rust.
Tested: extensive in-house and third-party durability testing.
Because engine-level rows are not available locally, see the Buyer's Guide tab to confirm the exact application for your vehicle.
Frequently Asked Questions
What vehicles does the Mevotech Supreme CMS7508 fit?
It is a direct-fit replacement for the 1993-1997 Ford Probe, 1993-1997 Mazda 626 and 1993-1997 Mazda MX-6. Check the Buyer's Guide tab to confirm the exact application for your vehicle.
What is a control arm and ball joint assembly?
It is a one-piece suspension arm with the ball joint integrated, so it both locates the wheel and lets the knuckle steer and pivot. The CMS7508 replaces the front left lower unit.
Does the CMS7508 include the mounting hardware?
Yes. An application-specific pinch bolt and locking nut are provided to help install the ball joint faster.
Is this a Ford Probe control arm as well as a Mazda 626 control arm?
Yes. This front left lower arm fits the 1993-1997 Ford Probe, Mazda 626 and Mazda MX-6. Confirm your specific application in the Buyer's Guide tab.
What are signs this control arm may need replacing?
Clunking over bumps, wandering or loose steering, and uneven tire wear can be signs of a worn control arm or ball joint. Diagnose the cause before replacing.
Write a Review
MEVOTECH
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS7508
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
