Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS801104
$122.99
(You save)
Keep your Mazda 3 control arm geometry tight with the Mevotech Supreme Suspension Control Arm and Ball Joint Assembly CMS801104 — a front left lower unit that locates the wheel, controls its travel, and links the chassis while the integrated ball joint allows steering and suspension movement. It's a direct-fit replacement for the 2007-2009 Mazda 3 (see the Buyer's Guide tab for full engine details).
Stamped steel construction: built to OE-level tolerances for the listed applications.
Corrosion resistance: a protective surface treatment helps prevent rust build-up.
Integrated ball joint: combines the lower control arm and ball joint in one assembly, with a rubber dust boot sealing the joint.
Labor Saver design: Mevotech's application-specific engineering and hardware are meant to speed installation.
Common signs that a 2008 Mazda 3 lower control arm needs attention include clunking or knocking over bumps, uneven tire wear, and loose or wandering steering — if a worn arm or ball joint is the cause, this Mevotech Supreme control arm replaces it. It's sold individually as the front left lower piece; for balanced suspension, consider replacing the opposite side as well.
What vehicles does the CMS801104 control arm and ball joint assembly fit?
It's a direct-fit replacement for the 2007-2009 Mazda 3 in the front left lower position. Check the Buyer's Guide tab to confirm the exact engine and application for your vehicle.
What position is this Mevotech Supreme suspension control arm?
This assembly is the front left (driver-side) lower control arm with an integrated ball joint for the listed Mazda 3 applications.
Is this a Mazda 3 trailing arm?
No. This is a front left lower control arm and ball joint assembly, not a trailing arm — it locates the front wheel and carries the lower ball joint.
What are the signs of a worn lower control arm or ball joint?
Clunking or knocking over bumps, uneven tire wear, and loose or wandering steering can indicate a worn arm bushing or ball joint. Have the cause diagnosed before replacing.
Do I need to replace both control arms?
This part is sold individually as the front left lower unit. For balanced suspension and even wear, it's good practice to inspect and consider replacing the opposite side too.
Write a Review
MEVOTECH
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS801104
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
