Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS861155
$95.99
(You save)
Tighten up worn steering and get your front suspension geometry back in line with the Mevotech Supreme Suspension Control Arm and Ball Joint Assembly (CMS861155) — a direct-fit Toyota Corolla control arm for the 2014-2022 Toyota Corolla. It replaces the front left (driver-side) lower control arm with the ball joint pre-installed, so it locates the wheel, allows suspension travel, and lets the wheel steer and articulate through the integrated ball joint. Mevotech Supreme parts are engineered in-house with application-specific upgrades and built for high-usage commercial and passenger vehicles, SUVs, fleets and working trucks.
Sintered bearings: engineered for superior toughness and longer-lasting performance.
Larger sphere design: an application-specific ball stud system with a larger sphere.
Stamped steel construction: built to OE-level tolerances.
Labor Saver install: secures to the vehicle with the part-specific castle nut provided for a quick, easy fit.
Resists corrosion: a protective surface treatment helps prevent rust build-up.
Sold individually as the front left lower unit; the opposite side is a separate part. If worn control-arm bushings or a loose ball joint are behind clunking over bumps, wandering steering or uneven tire wear, this assembly replaces them.
Does this control arm and ball joint assembly fit my Toyota Corolla?
It's a direct-fit front left lower unit for the 2014-2022 Toyota Corolla. Check the Buyer's Guide tab to confirm the exact year, engine and trim for your vehicle.
Which side and position does CMS861155 cover?
This is the front left (driver-side) lower control arm. It is sold individually, so the right side is a separate part if you're replacing both.
Is the ball joint included, and does it come with hardware?
Yes—the ball joint is pre-assembled into the arm, and a part-specific castle nut is provided to secure it to the vehicle during installation.
What are signs my lower control arm may need replacing?
Clunking or knocking over bumps, loose or wandering steering, and uneven tire wear can point to a worn ball joint or control-arm bushings. Diagnose the cause before replacing.
What is this Mevotech Supreme control arm made of?
Stamped steel construction with a protective surface treatment that resists corrosion, plus sintered bearings engineered for longer-lasting performance.
Write a Review
Mevotech Supreme
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS861155
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
