Monroe Shocks & Struts Suspension Shock Absorber P/N:C1517
MONROE SHOCKS/STRUTS C1514 rear right shock absorber for the 2005-2010 Volkswagen Passat adjusts its damping in real time through the car's electronic control unit. It is a direct OE replacement designed to OE specifications for vehicles originally equipped with electronic suspension, and some catalogs list it as a suspension shock absorber.
A worn shock can show up as a bouncy ride, wheel hop or oil streaking down the body. Other suspension parts can cause similar signs, so with the car parked and the engine off, look the shock over for leaking fluid and check its mounts before you replace it.
This shock absorber is a direct OE replacement for the 2005-2010 Volkswagen Passat and the 2012-2013 Volkswagen Passat. The listing is one shock for the rear right; the rear left of that axle is a separate part, and the two sides are normally done at the same time.
Fit and size
Build and materials
One rear right shock absorber with mounting hardware; a dust shield is not included. This listing holds one shock, and the rear right position takes one.
Interchange: 3C0513046D · 3C0513046E · 7N0513046
This part cross-references / interchanges with the following part numbers:
Does the Monroe C1514 work as a Passat shock absorber on the 2005-2010 Volkswagen Passat?
Yes. Monroe C1514 is the rear right shock absorber for the 2005-2010 Volkswagen Passat, and the rear right position takes one.
Is this a VW Passat rear shock absorber for the 2012-2013 Volkswagen Passat?
Yes. Monroe C1514 also fits the 2012-2013 Volkswagen Passat as the rear right shock; the rear left on that axle is a separate part.
Does the Monroe RideSense C1514 come with mounting hardware?
Yes. Mounting hardware is included with this rear right shock, but a dust shield is not. The listing holds one shock.
Is this rear right shock gas charged, and how long is it extended?
Yes. It is gas charged, and its self-lubricating fluid seal retains the gas around the chrome-plated piston rod. Extended length is 23.2 in (589.3 mm).
How does the RideSense rear shock connect to the car's electronic suspension?
It has an electronic cable for plug-and-play connection to the vehicle's electronic control unit. Its mounting locations match the OE design.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.