Smooth out a worn front corner and restore factory ride height with the Monroe Quick-Strut 172609 Front Left Suspension Strut and Coil Spring Assembly. This fully assembled unit drops in as a direct-fit replacement for the 2008-2012 Nissan Rogue — see the Buyer's Guide tab for engine-level details. Fit checked and ride tested, it bundles the upper strut mount, application-specific coil spring, and strut into one preassembled unit, so there's no need for a spring compressor during installation.
Its premium upper strut mount helps deliver smooth, like-new steering while reducing body sway, vibration, and road harshness. Backed by Monroe's Limited Lifetime Warranty and the Feel the Difference™ Guarantee.
Interchange: LS5494511L · 33NS1112
This part cross-references / interchanges with the following part numbers:
What vehicle does the Monroe 172609 Quick-Strut fit?
It's a direct-fit replacement for the 2008-2012 Nissan Rogue in the front left position. Check the Buyer's Guide tab to confirm the fit for your specific vehicle.
What position is this strut assembly for?
This is the front left (driver's side on left-hand-drive vehicles) Quick-Strut assembly.
Do I need a spring compressor to install it?
No. The 172609 comes as a fully assembled unit with the upper mount, coil spring, and strut preassembled, so no spring compressor is required.
What's included in the Quick-Strut assembly?
It includes everything needed for strut replacement in a single unit: a preassembled upper strut mount, application-specific coil spring, and strut.
Should I replace both sides at the same time?
This listing is for one front left assembly. Replacing struts in pairs is a common best practice for balanced ride and handling; follow the vehicle service information.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
