Take the guesswork out of strut replacement with the Monroe Quick-Strut Suspension Strut and Coil Spring Assembly 172926, a fully preassembled front-left unit that drops into your 2012 Honda Civic with no spring compressor required. Every major wear component — strut, application-specific coil spring, and upper mount — arrives in one ready-to-install assembly designed to restore the ride characteristics your Civic left the factory with. See the Buyer's Guide tab for engine-level fitment.
A protective coating resists rust and corrosion, and the assembly is backed by Monroe's Limited Lifetime Warranty and Feel the Difference Guarantee.
Interchange: LS3381091L · 33HN1175
This part cross-references / interchanges with the following part numbers:
What vehicle does this Quick-Strut fit?
It is a direct-fit front-left assembly for the 2012 Honda Civic. Check the Buyer's Guide tab to confirm the correct application for your vehicle.
Which corner does this assembly cover?
This is the front left (driver-side front) unit. It's sold individually, so order the matching front-right assembly if you're replacing both sides.
Do I need a spring compressor to install it?
No. The strut, coil spring, and upper mount come preassembled in one unit, so there's no need for a spring compressor during installation.
What's included in the assembly?
It combines the strut, an application-specific coil spring, and a premium upper strut mount into a single fully assembled, ready-to-install unit.
Should I replace both front struts at once?
Replacing struts in pairs is recommended for balanced, even ride and handling. This listing covers one front-left assembly, so add the opposite side for a matched set.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
