MOOG Chassis Products Steering Tie Rod End P/N:DS1159

Tighten up loose, wandering steering with the MOOG Chassis Products Steering Tie Rod End DS1159, a front left inner tie rod end that links the steering to the wheel and helps hold your alignment. It's a direct-fit replacement for the 1989-1990 Ford Bronco II, 1989-1997 Ford Ranger, and 1994-1997 Mazda B2300, B3000, and B4000 — see the Buyer's Guide tab for engine-level fitment.

• Belleville preload washer: helps absorb impact and reduce spring bind and shattering during shock loads.
• Problem Solver Gusher Bearing: metal-to-metal design adds strength and lets grease flow through the bearing surface to reduce friction.
• Heat-treated ball studs: treated to match or exceed OE requirements to inhibit premature failure and improve fatigue strength.
• Pressed-in cover plate & greaseable socket: the patented pressed-in cover plate seals out debris while the greaseable socket lets fresh lubricant flush contaminants.

Signs an inner tie rod end may need replacing include loose or wandering steering, uneven tire wear, or a clunk when turning. If a worn inner tie rod end is the cause, this MOOG unit replaces it. Precision tolerances are designed for straightforward installation and steering alignment.