Tighten up loose, wandering steering with the MOOG ES801127 Steering Tie Rod End, a front right outer unit engineered to connect the steering linkage to the steering knuckle. It drops in as a direct-fit replacement for the 2013-2015 Chevrolet Malibu and the 2016 Chevrolet Malibu Limited (see the Buyer's Guide tab for engine details), and is also cataloged under the QuickSteer ES801127 number.
Greaseable socket: allows new lubricant to flush contaminants, helping reduce corrosion and wear.
Problem Solver Gusher Bearing: a metal-to-metal design that lets grease flow through the bearing surface for reduced friction and long life.
Belleville preload washer: helps absorb impact and keep the bearing package tight as the bearings wear.
Heat-treated ball stud: treated to match or exceed OE requirements to inhibit premature failure and improve fatigue strength.
A patented pressed-in cover plate seals out debris and minimizes looseness, while the coated finish adds corrosion resistance. Designed for OE fit and function with precision tolerances for easy installation and steering alignment. Replacement helps restore vehicle handling.
Interchange: 310-512357 · 544-646
310512357 · 544646 · 45A10056 · TA5779 · TO91142XL · TO91142PR · 13354598 · MS50645 · 2693925 · 2694039 · 4012588
This part cross-references / interchanges with the following part numbers:
What vehicles does the MOOG ES801127 tie rod end fit?
It's a direct-fit front right outer tie rod end for the 2013-2015 Chevrolet Malibu and the 2016 Chevrolet Malibu Limited. Check the Buyer's Guide tab to confirm the fit for your vehicle.
What does a steering tie rod end do?
It connects the steering linkage to the steering knuckle, transferring steering input to the wheel. A worn end can allow play in the steering and uneven tire wear.
Is this tie rod end greaseable?
Yes. It uses a greaseable socket that lets new lubricant flush contaminants, helping reduce corrosion and wear inside the joint.
What are signs my tie rod end may need replacing?
Common signs include loose or wandering steering, a clunk or rattle from the steering, and uneven tire wear. Have the steering diagnosed to confirm the cause before replacing.
Should I get a wheel alignment after installing this part?
Yes. Replacing a tie rod end affects toe settings, so a professional wheel alignment is recommended after installation for proper steering and even tire wear.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
