MOOG Chassis Products Suspension Control Arm and Ball Joint Assembly P/N:RK623014
$117.99
(You save)
Replace a worn Toyota Camry control arm with the MOOG RK623014 Suspension Control Arm and Ball Joint Assembly, a front right lower unit engineered for structural strength and corrosion protection. It installs as a direct-fit replacement for the 1997-2001 Toyota Camry, 1997-1998 Toyota Avalon, 1997-2001 Lexus ES300, and 1999-2003 Lexus RX300. The control arm locates the wheel and sets suspension geometry, while the integrated ball joint lets the knuckle pivot for steering and suspension travel — if a loose or worn original arm/joint is behind clunking, wandering, or uneven tire wear, this assembly replaces it.
Carbon fiber-reinforced bearing: paired with induction-hardened studs to reduce socket friction and resist breakage for longer socket life.
Greaseable socket: lets fresh lubricant flush out contaminants to ease maintenance and reduce wear.
Pre-installed dust boot seal and premium bushings: the boot blocks wear-causing dirt and water, and the bushings are tuned to inhibit noise for a comfortable ride.
Hardware included: comes with the necessary hardware for a fast install, plus a laser-etched ID marking genuine MOOG quality.
See the Buyer's Guide tab for full engine-level fitment.
It's a direct-fit replacement for the 1997-2001 Toyota Camry, 1997-1998 Toyota Avalon, 1997-2001 Lexus ES300, and 1999-2003 Lexus RX300. See the Buyer's Guide tab for engine-level fitment.
What position is this MOOG assembly?
It is the front right lower control arm and ball joint assembly. Confirm it matches the corner you need before ordering.
Is a Lexus RX300 control arm the same part?
Yes, the RK623014 is listed as the front right lower control arm for the 1999-2003 Lexus RX300, along with the listed Toyota and other Lexus applications.
Does this control arm come with hardware?
Yes. Per MOOG, it comes with the necessary hardware for installation, plus a pre-installed dust boot seal and pre-installed premium bushings.
Can I grease the ball joint?
Yes, it uses a greaseable socket, which lets fresh lubricant flush out contaminants to reduce corrosion and wear during maintenance.
Write a Review
MOOG
MOOG Chassis Products Suspension Control Arm and Ball Joint Assembly P/N:RK623014
Renew worn steering and handling on your rig with the MOOG Chassis Ford Expedition control arm and ball joint assembly, MPN RK622137. This rear upper rearward control arm and ball joint assembly...
MOOG RK620334 Front Left Lower Suspension Control Arm and Ball Joint Assembly for Toyota CamryMOOG premium control arms for foreign and domestic nameplates are engineered for structural strength and...
MOOG RK620566 Front Right Lower Suspension Control Arm and Ball Joint Assembly for Nissan VersaFront Right Lower Suspension Control Arm and Ball Joint AssemblyMOOG premium control arms for foreign...
MOOG RK620384 Front Left Lower Suspension Control Arm and Ball Joint Assembly for Mitsubishi LancerFront Left Lower Suspension Control Arm and Ball Joint AssemblyMOOG premium control arms for foreign...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
