MOOG Chassis Products Suspension Control Arm and Ball Joint Assembly P/N:RK623788
$106.99
(You save)
Bring quiet, precise steering back to your ride with the MOOG Chassis Tesla Y control arm and ball joint assembly (RK623788). This front left upper unit drops in as a direct-fit replacement for the 2020-2022 Tesla Y and the 2017-2022 Tesla 3, locating the wheel and linking the suspension to the chassis while the integrated ball joint allows the steering and suspension to move together. When a worn arm or ball joint is the cause of clunking on acceleration or bumps, loose steering, or uneven tire wear, this assembly replaces it.
Induction-hardened studs: studs are induction hardened to maximize strength, resist breakage, and improve fatigue life.
Pre-installed dust boot seal: provides a barrier that helps keep dirt and water out to guard against wear-causing contaminants.
Added corrosion protection: specially-engineered coatings are applied to metal surfaces to inhibit premature deterioration from rain, snow, salt, and road grime.
Premium bushings: pre-installed with optimized stiffness to inhibit noise for a comfortable ride.
Hardware included: comes with the necessary hardware for a fast installation, with precision tolerances that aid steering alignment.
Looking for a Tesla 3 control arm? This same assembly covers the listed 2017-2022 applications.
What vehicles does the MOOG RK623788 control arm and ball joint assembly fit?
It is a direct-fit front left upper replacement for the 2017-2022 Tesla 3 and the 2020-2022 Tesla Y. See the Buyer's Guide tab to confirm your exact vehicle.
Which corner of the vehicle is this control arm for?
This is the front left (driver's side) upper control arm. It installs on that specific position, so verify it matches the corner you need to replace.
Does this assembly come with the ball joint and hardware?
Yes. The ball joint is integrated into the assembly, and it comes with the necessary mounting hardware for installation.
What are signs this control arm and ball joint may need replacing?
Common signs include clunking over bumps or on acceleration, loose or wandering steering, and uneven tire wear. Have the cause diagnosed, since these symptoms can have other sources.
How are the studs and bushings built on this MOOG assembly?
The studs are induction hardened to resist breakage and improve fatigue life, and the bushings are pre-installed with optimized stiffness to inhibit noise for a comfortable ride.
Write a Review
MOOG
MOOG Chassis Products Suspension Control Arm and Ball Joint Assembly P/N:RK623788
Renew worn steering and handling on your rig with the MOOG Chassis Ford Expedition control arm and ball joint assembly, MPN RK622137. This rear upper rearward control arm and ball joint assembly...
MOOG RK622910 Front Left Lower Suspension Control Arm and Ball Joint Assembly for Mercedes-Benz CLA250Front Left Lower Suspension Control Arm and Ball Joint AssemblyMOOG premium control arms for...
MOOG RK620334 Front Left Lower Suspension Control Arm and Ball Joint Assembly for Toyota CamryMOOG premium control arms for foreign and domestic nameplates are engineered for structural strength and...
MOOG RK620566 Front Right Lower Suspension Control Arm and Ball Joint Assembly for Nissan VersaFront Right Lower Suspension Control Arm and Ball Joint AssemblyMOOG premium control arms for foreign...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
