MOOG Chassis Products Suspension Control Arm and Ball Joint Assembly P/N:RK623955
$145.99
(You save)
Keep the front wheel precisely located and the ride quiet with the MOOG Suspension Control Arm and Ball Joint Assembly RK623955. This front right upper unit is a direct-fit replacement for the 2014-2021 Tesla S (see the Buyer's Guide tab for full application details), pairing the control arm and ball joint in one ready-to-install assembly. MOOG premium control arms for foreign and domestic nameplates are engineered for structural strength and corrosion protection.
Keeps dirt and water out: a pre-installed dust boot seal forms a barrier against wear-causing contaminants.
Added corrosion protection: specially-engineered coatings are applied to metal surfaces to inhibit deterioration from rain, snow, salt and road grime.
Premium bushings: pre-installed with optimized stiffness to inhibit noise for a comfortable ride.
Hardware included: comes with all necessary hardware, and precision tolerances support easy installation and steering alignment.
Signs the original may need replacing include clunking on acceleration or over uneven pavement, uneven tire wear, loose or wandering steering, and worn or torn bushings or ball-joint boots. If a failed control arm or ball joint is the cause, this assembly replaces both in one part. Have an alignment performed after installation.
It is a direct-fit replacement for the 2014-2021 Tesla S. Check the Buyer's Guide tab to confirm it matches your specific vehicle.
Is this a front or rear part?
This assembly is cataloged as the front right upper control arm and ball joint unit for the listed Tesla S applications.
Does it include the ball joint and mounting hardware?
Yes. The ball joint comes pre-assembled to the control arm, and per MOOG the unit comes with all necessary hardware for installation.
What are the signs my control arm or ball joint is failing?
Common signs include clunking on acceleration or over bumps, uneven tire wear, loose or wandering steering, and torn bushings or ball-joint boots. Diagnose the cause before replacing.
Do I need an alignment after installing it?
An alignment is recommended after replacing a control arm and ball joint assembly to restore correct steering geometry. Consult your service information for specs.
Write a Review
MOOG
MOOG Chassis Products Suspension Control Arm and Ball Joint Assembly P/N:RK623955
MOOG RK641493 Front Right Lower Suspension Control Arm and Ball Joint Assembly for Chevrolet AstroFront Right Lower Suspension Control Arm and Ball Joint AssemblyMOOG premium control arms for foreign...
MOOG RK623653 Front Right Lower Suspension Control Arm and Ball Joint Assembly for Volvo S60MOOG premium control arms for foreign and domestic nameplates are engineered for structural strength and...
MOOG RK623636 Front Left Lower Forward Suspension Control Arm and Ball Joint Assembly for Cadillac CTSFront Left Lower Forward Suspension Control Arm and Ball Joint AssemblyMOOG premium control arms...
Keep your front suspension tight and your steering precise with the MOOG Chassis Products Front Left Lower Suspension Control Arm and Ball Joint Assembly (RK620056). This assembly combines the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
