MOOG Chassis Products Suspension Control Arm and Ball Joint Assembly P/N:RK80884

Tighten up steering and restore proper front-suspension geometry with the MOOG Chassis RK80884 Front Left Upper Suspension Control Arm and Ball Joint Assembly. It drops in as a direct-fit replacement for the 1997-2001 Honda CR-V (see the Buyer's Guide tab for engine-level fitment), combining the control arm, bushings, and a pre-installed ball joint in one ready-to-bolt assembly.

• Carbon fiber bearings: Induction-hardened studs add strength, while a patent-pending carbon fiber-reinforced bearing reduces socket friction compared to typical non-reinforced bearings for longer socket life.
• Optimized bushings: Engineered for quiet operation and resistance to wear, salt, road grime, and oils.
• Greaseable, sealed socket: The pre-installed ball joint uses a sealed socket, and a greaseable design lets fresh lubricant flush out contaminants during maintenance.
• Corrosion protection: Coated studs plus e-coated cast iron and steel control arms help inhibit premature deterioration.

The assembly is heat treated to match or exceed OE requirements, the ball stud shape is designed to support fatigue life and compensate for suspension sag, and precision tolerances aid installation and steering alignment. Laser-etched ID marks genuine MOOG quality, and all necessary mounting hardware is included.