MOOG LK002PB rear right suspension knuckle assembly for the 2002-2005 Ford Explorer and other vehicles holds the wheel bearing and hub on the knuckle as one unit.
- Pre-assembled unit with a knuckle, wheel hub with studs and a bearing
- E-coated backing plate and knuckle for corrosion resistance
- Tested by MOOG engineers throughout design and development
Quick facts
- Part: MOOG LK002PB suspension knuckle assembly
- Also called: wheel bearing and hub assembly
- Fits: 2002-2005 Ford Explorer and other vehicles
- Position: Rear right
- Condition: New
A rumbling or humming noise from the rear wheel can mean the bearing in this assembly is worn, though a tire or a brake rotor can make a similar noise, so find the source before replacing it.
Fits
It fits the 2002-2005 Ford Explorer and the 2002-2005 Mercury Mountaineer. This listing is one rear right assembly; the rear left on that axle is a separate part, and the two sides are normally replaced at the same time.
Specifications
Fit and size
- Position: rear right
- Quantity per vehicle: 1
Build and materials
- Construction: pre-assembled, bolt-on knuckle assembly
- Coating: e-coated backing plate and knuckle
- Condition: New
- Country of origin: China
In the box
One rear right assembly with its axle nut and backing plate, plus a ball joint where applicable. The rear right side takes one; the rear left is ordered separately.
Installation notes
- Comes pre-assembled and bolts on.
- Designed so no press or special tools are needed for the bearing replacement.
Interchange: 698-012
3L2Z5A968BA
Frequently Asked Questions
Will this work as a wheel bearing for the 2002-2005 Ford Explorer?
Yes. MOOG LK002PB fits the 2002-2005 Ford Explorer on the rear right and has the bearing built into a pre-assembled knuckle and hub unit.
Is this a wheel bearing for the 2002-2005 Mercury Mountaineer?
Yes. MOOG LK002PB fits the 2002-2005 Mercury Mountaineer on the rear right, with the bearing already assembled into the knuckle and hub.
Does this wheel bearing and hub assembly come with the axle nut and studs?
Yes. This rear right unit has the wheel hub with studs, bearing, axle nut and backing plate, plus a ball joint where applicable. The listing is one assembly.
Are the knuckle and backing plate on this rear right assembly e-coated?
Yes. The backing plate and knuckle on this MOOG LK002PB carry an e-coat that gives corrosion resistance.
Do I need a press to install the MOOG LK002PB?
No. The MOOG LK002PB is a pre-assembled bolt-on unit designed so bearing replacement needs no press or special tools.
