MOOG LK041 front left suspension knuckle assembly for the 2007-2011 Toyota Camry replaces the wheel bearing, hub and knuckle as one pre-assembled unit. Also called a wheel bearing and hub assembly, it takes the place of the separate parts at the front left wheel.
- Pre-assembled with a MOOG knuckle, wheel hub with studs, bearing, axle nut and backing plate
- E-coated backing plate and knuckle for corrosion resistance
- Tested by MOOG engineers throughout design and development
Quick facts
- Part: MOOG LK041 suspension knuckle assembly
- Also called: wheel bearing and hub assembly
- Fits: 2007-2011 Toyota Camry
- Position: Front left
- Condition: New
A humming or growling noise that changes with speed, or vibration from one front corner, can mean the wheel bearing is worn. These signs alone do not prove this assembly is the problem, since an unevenly worn tire can make a similar noise.
Fits
It fits the 2007-2011 Toyota Camry.
Specifications
Fit and size
- Position: Front left
- Quantity per vehicle: 1 for the front left position
Build and materials
- Type: Complete suspension knuckle assembly
- Coating: E-coated backing plate and knuckle
- Condition: New
- Country of origin: China
In the box
One front left assembly with the knuckle, wheel hub with studs, bearing, axle nut and backing plate, plus a ball joint where applicable. The front left takes one; the front right is a separate part ordered separately, and the two are normally replaced together.
Installation notes
- Bolt-on, pre-assembled unit designed to make bearing replacement easier.
- No special tools or press are needed for the bearing.
Interchange: 43212AA010
Frequently Asked Questions
Does the MOOG LK041 fit the 2007-2011 Toyota Camry?
Yes. MOOG LK041 is the front left knuckle assembly for the 2007-2011 Toyota Camry. The front right side is a separate part.
What parts come with the MOOG LK041 knuckle assembly?
MOOG LK041 comes with the knuckle, wheel hub with studs, bearing, axle nut and backing plate, plus a ball joint where applicable. This listing is one front left unit.
Is the knuckle on this assembly protected against rust?
Yes. The knuckle and the backing plate on this assembly are e-coated for corrosion resistance.
What does a worn front wheel bearing sound like?
A humming or growling noise that changes with road speed, or vibration from one front corner, can point to a worn bearing. A shop can confirm it.
Do I need a press to install the MOOG LK041?
No. MOOG LK041 is a bolt-on, pre-assembled unit designed to remove the need for a press or special tools when replacing the bearing.
