NTK Engine Coolant Temperature Sensor P/N:EF0090
NTK EF0153 coolant temperature sensor for the 2002-2005 Audi A4 V6 3.0L, the 2002-2006 A4 4-cylinder 1.8L, the 2005-2017 A4 4-cylinder 2.0L, the 2006-2008 A4 V6 3.2L, the 2011-2014 A4 4-cylinder 1.8L and other vehicles determines the temperature of the engine coolant and sends an analog signal to the ECM. The ECM uses that signal to keep the air/fuel ratio right and to run the cooling fan(s) and temperature gauge.
A check engine light, an erratic or dead temperature gauge, erratic or no cooling fan operation and overheating can mean this sensor is worn. A thermostat or fan relay problem can show up the same way, so find which part is at fault before you replace the sensor.
It works as an Audi A4 coolant temperature sensor replacement for the 2011-2014 A4 4-cylinder 1.8L and as a coolant temperature sensor for the 2006-2013 Audi A3 4-cylinder 2.0L and the 2002-2017 Volkswagen Jetta 4-cylinder 2.0L. Wires, probe length and thermistor placement match OE. This listing is one sensor, and the 2002-2005 Audi A4 V6 3.0L takes one. If your car is not named here, look up its year and engine in the "Vehicles it fits" section.
Fit and size
Build and materials
Interchange: 158-0784 · 955 106 125 01 · TS-608 · 06A 919 501 · 06A 919 501A · 211-1056
WT7257 · TS10278 · TS7256
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this a VW Jetta coolant temperature sensor for the 2002-2017 Volkswagen Jetta 4-cylinder 2.0L?
Yes. NTK EF0153 is listed for the 2002-2017 Volkswagen Jetta 4-cylinder 2.0L, and that car takes one sensor.
Does this work as an Audi A4 temperature sensor on the 2005-2017 A4 4-cylinder 2.0L?
Yes. NTK EF0153 is listed for the 2005-2017 Audi A4 4-cylinder 2.0L, and that engine takes one sensor.
What is the NTK EF0153 sensor housing made of, and what is inside?
The housing is brass. Thermal conductive grease inside it increases sensor response time and carries temperature accurately to the thermistor.
Does this sensor come with thread sealant or an o-ring?
Where applicable, the sensor comes with thread sealant or an o-ring already on it, and mounting clip(s) are included where applicable.
Where is an engine coolant temperature sensor located?
Depending on the engine, it may sit on the cylinder head, engine block, thermostat housing or intake manifold. This sensor's position is listed as right, left, lower.
Published by the manufacturer of this part. Links open in a new tab.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.