NTK Engine Coolant Temperature Sensor P/N:EF0053
NTK EF0155 rear coolant temperature sensor for the 2020-2023 Jeep Wrangler V6 3.0L and other vehicles reads engine coolant temperature for the ECM. Also sold as an engine coolant temperature sensor, it sends an analog signal that helps the ECM set the air/fuel ratio and supports cooling fan and temperature gauge operation.
Reasons to replace it include a lit check engine light, a temperature gauge that reads erratically or not at all, or a cooling fan that runs erratically or not at all. A damaged wiring connector, a sticking thermostat or a failing fan motor can be behind those symptoms too, so trace the cause before buying a sensor.
The listing covers a wide range of Jeep, Chevrolet, Cadillac and Saab models, with a coolant temperature sensor for the 2018-2022 Chevrolet Colorado 4-cylinder 2.8L and the 2014-2021 Jeep Grand Cherokee V6 3.0L among them. Each takes one, and the wire and probe length match OE. Open the "Vehicles it fits" section to check your exact model and engine.
Fit and size
Build and materials
One coolant temperature sensor, with mounting clip(s) where applicable.
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this ECT sensor the right one for a 2020-2023 Jeep Wrangler V6 3.0L?
Yes. NTK EF0155 is listed for the 2020-2023 Jeep Wrangler V6 3.0L, and that vehicle takes one sensor.
Is this a Chevy Colorado coolant temperature sensor for the 2018-2022 4-cylinder 2.8L?
Yes. NTK EF0155 is listed for the 2018-2022 Chevrolet Colorado 4-cylinder 2.8L. The "Vehicles it fits" section shows the other models and engines.
Does this NTK sensor come with a mounting clip?
Mounting clip(s) are included where applicable, and thread sealant or an o-ring is already installed where applicable.
What does the grease inside the brass housing of this sensor do?
The thermal conductive grease inside the brass housing increases sensor response time. It also carries coolant temperature to the thermistor accurately.
Where is a coolant temperature sensor mounted on the engine?
Depending on the engine, it may sit on the cylinder head, the engine block, the thermostat housing or the intake manifold.
Published by the manufacturer of this part. Links open in a new tab.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.