Replace a leaking or sticking rear right caliper with the Nugeon brake caliper 97-17269A, a remanufactured unit cataloged for the rear right position. It is a direct-fit replacement for many vehicles, among them the 1990-1994 Chevrolet Lumina, 1989-1993 Buick Regal and 1988-1993 Oldsmobile Cutlass Supreme; see the Buyer's Guide tab for the full list.
This remanufactured disc brake caliper presses the pads against the rotor when the pedal is applied, turning hydraulic pressure into the clamping force that slows the wheel.
Not included: brake pads, mounting bracket, bracket mounting bolts, mounting bolt, caliper slides, anti-squeal shims, wear sensors and bleeder screw cap. The caliper is listed with FMSI pad number D377.
Signs a caliper may need replacing include brake fluid seeping at the caliper, a pull to one side when braking, a dragging or sticking brake, or uneven pad wear. If the caliper is the cause, this Nugeon caliper replaces it. Bleed the brake system after installation as directed by the vehicle service information.
Housing cast numbers: 808, 311, R, OR, 315. Quantity per application: 1. Country of origin: Mexico.
Is this a 1989-1993 Buick Regal brake caliper for my car?
It is listed for the rear right position on the 1989-1993 Buick Regal, all engines. Check the Buyer's Guide tab for the other listed vehicles.
Which position does this 1988-1993 Oldsmobile Cutlass Supreme brake caliper fit?
It is cataloged for the rear right position on the 1988-1993 Oldsmobile Cutlass Supreme and the other listed applications. Each application uses one.
What hardware comes with it?
It includes the bleeder screw, dust boots, caliper and pad hardware, mounting hardware and crush washers. Pads, the bracket, bracket bolts, caliper slides and anti-squeal shims are not included.
What brake pads does it use?
The caliper is listed with FMSI pad number D377. Pads are not included, so order them separately if your current pads are worn.
What are the piston and thread specs?
It has one steel piston, 35 mm (1.378 in) in diameter, a banjo bolt inlet with an M10-1.5 thread, and an M10-1.5 x 29.5 bleeder screw.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
