Nugeon 99-00829A front left brake caliper for the 2005 Hyundai Tucson and other vehicles squeezes the pads against the rotor to slow the wheel. It is a remanufactured floating caliper.
- Single steel piston, 60 mm in diameter
- Cast iron housing with a rust-preventative finish
- Banjo bolt inlet fitting for the brake line
Quick facts
- Part: Nugeon 99-00829A brake caliper
- Also called: disc brake caliper
- Fits: 2005 Hyundai Tucson and other vehicles
- Position: Front left
- Material: Cast iron housing, steel piston
- Condition: Remanufactured
Pulling to one side, a dragging wheel or fluid around the dust boot can mean the caliper is failing. A worn rotor or a collapsed brake hose can be behind those signs too, so find the cause before you buy.
Fits
This is a direct-fit brake caliper for the front left of the 2005 Hyundai Tucson and the 2005 Kia Sportage, and each takes one. This listing is one caliper; the front right is a separate part, and the two sides are normally replaced together.
Specifications
Fit and size
- Position: Front left
- Quantity per vehicle: 1
- Piston diameter: 60 mm (2.36 in)
- Piston quantity: 1
- Inlet port thread: M10-1.0 x 23.4 mm
- Bleeder screw thread: M10-1.0
- Housing cast number: BC140092
Build and materials
- Caliper type: Floating
- Condition: Remanufactured
- Housing material: Cast iron
- Piston material: Steel
- Finish: Rust preventative
- Country of origin: Mexico
In the box
One brake caliper with its mounting bracket, caliper slides, dust boots, bleeder screw and crush washers. Pads, anti-squeal shims, wear sensors and the bleeder screw cap are not included. The bracket mounting bolts are not included either, so plan on new ones, since the old bolts may not be reusable.
Frequently Asked Questions
Is this Nugeon brake caliper made for the front left of the 2005 Kia Sportage?
Yes. Nugeon 99-00829A fits the front left of the 2005 Kia Sportage and the 2005 Hyundai Tucson, and each takes one.
Does the Nugeon caliper come with the mounting bracket and bleeder screw?
Yes, Nugeon 99-00829A includes the mounting bracket, caliper slides, dust boots, bleeder screw and crush washers; pads, shims and bracket bolts are not included.
Is this disc brake caliper a floating or fixed design?
It is a floating caliper with one 60 mm steel piston, in a cast iron housing.
What thread does the bleeder screw on this caliper use?
The bleeder screw is M10-1.0. The inlet is a banjo bolt fitting with an M10-1.0 x 23.4 mm port thread.
Can I keep driving with a leaking front caliper?
No. A leaking caliper affects braking, so have it checked and replaced promptly.
