Nugeon Disc Brake Caliper P/N:99-00848A
Nugeon 99-00878B front right brake caliper for the 2015-2019 Hyundai Sonata and other vehicles presses the pads against the rotor to slow the wheel. This Nugeon brake caliper is remanufactured and covers the front right wheel only.
A pull to one side when braking, fluid wetness around the wheel, or one pad wearing much faster than the other can mean the caliper is failing. A collapsed brake hose or worn pads can sit behind the same signs, so track down the real cause first.
The 2015-2019 Hyundai Sonata, the 2016-2020 Kia Optima and the 2019-2021 Hyundai Kona Electric are among the vehicles this brake caliper fits. Open the "Vehicles it fits" section to check your exact model and engine. The 2015-2019 Hyundai Sonata takes one on the front right; the front left is a separate caliper ordered on its own, and the two sides are normally replaced together.
Fit and size
Build and materials
One remanufactured caliper with its bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw with cap, and crush washers. Brake pads, wear sensors, anti-squeal shims, the caliper mounting bolt and the bracket mounting bolts are not included, so plan on new bolts.
Interchange / FMSI:
FMSI: D1803
Is this caliper for the 2015-2019 Hyundai Sonata the front right side?
Yes. Nugeon 99-00878B is the front right caliper for the 2015-2019 Hyundai Sonata. Open the "Vehicles it fits" section to check your exact engine; the left side is a separate caliper.
Is this the right brake caliper for the 2016-2020 Kia Optima?
Yes. This front right brake caliper fits the 2016-2020 Kia Optima. The front left side takes its own caliper, ordered separately.
Is this disc brake caliper floating or fixed, and how big is the piston?
This front right caliper is floating, with one steel piston that is 60 mm (2.36 in) in outside diameter. The casting is aluminum and cast iron.
What comes with this Nugeon caliper?
Nugeon 99-00878B includes the bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw with cap and crush washers. Pads, wear sensors, anti-squeal shims and mounting bolts are not included.
What thread sizes does this caliper use for the bleeder screw and the inlet?
The bleeder screw is M10-1.0. The inlet is a banjo bolt fitting with an M10 - 1.0 thread.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.