Nugeon Disc Brake Caliper P/N:99-17918B
Nugeon 99-01037A rear right brake caliper for the 2016-2021 Honda Pilot and other vehicles squeezes the brake pads against the rotor to slow the wheel. This remanufactured Nugeon brake caliper is a floating design with one piston and comes with its bracket.
A sticking disc brake caliper can show up as the car pulling to one side, a fluid leak at the wheel or uneven pad wear. A collapsed brake hose is another common cause, so those signs alone do not prove the caliper is the problem.
The 2016-2021 Honda Pilot, the 2020-2025 Honda Passport and the 2017-2022 Honda Ridgeline all fit this caliper, along with other vehicles. Open the "Vehicles it fits" section to check your exact model and engine. This listing is one caliper for the rear right; each side of the rear axle takes one, and the rear left is a separate part that is normally done at the same time.
Fit and size
Build and materials
One remanufactured brake caliper with its mounting bracket, caliper slides, dust boots, bleeder screw, wear sensors, caliper and pad hardware and crush washers. Brake pads, anti-squeal shims, the bleeder screw cap and the bracket mounting bolts are not included, so plan on new mounting bolts.
Is this a Honda Pilot caliper for the rear right side of the 2016-2021 Honda Pilot?
Yes, Nugeon 99-01037A is a rear right caliper that fits the 2016-2021 Honda Pilot; the rear left is a separate part, and your exact model and engine can be checked in the "Vehicles it fits" section.
Is Nugeon 99-01037A a Honda Ridgeline brake caliper for the 2017-2022 Honda Ridgeline?
Yes, Nugeon 99-01037A is a rear right caliper that fits the 2017-2022 Honda Ridgeline, with one caliper per side of the axle.
Does this Nugeon caliper come with brake pads?
No, brake pads, anti-squeal shims, the bleeder screw cap and the bracket mounting bolts are not included with this rear right caliper; the bracket, slides, dust boots, bleeder screw, wear sensors and hardware are.
What are the piston size and thread sizes on this rear right brake caliper?
The single phenolic piston is 43 mm (1.693 in) across. The banjo bolt inlet has an M10-1.0 x 23.4 port thread, and the bleeder screw is M10-1.0.
Is Nugeon 99-01037A a floating or fixed caliper?
Floating, with one piston; this remanufactured caliper has a cast iron casting with a rust-preventative finish.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.