Nugeon 99-01674B rear left brake caliper for the 2004-2007 Toyota Highlander clamps the brake pads against the rotor to slow the vehicle. This remanufactured Nugeon brake caliper uses hydraulic pressure from the brake pedal to push its piston.
- Floating caliper with a single steel piston
- Cast iron housing with a rust-preventative finish
- Banjo bolt inlet fitting
Quick facts
- Part: Nugeon 99-01674B brake caliper
- Also called: disc brake caliper
- Fits: 2004-2007 Toyota Highlander
- Position: Rear left
- Material: Cast iron housing, steel piston
- Condition: Remanufactured
A rear brake that drags, wears its pads unevenly or leaks fluid near the caliper can mean the caliper needs replacing. A sticking slide, worn pads or a damaged rotor or brake hose can show the same signs, so find the cause before you buy. Calipers on one axle are normally replaced together; this listing is one.
Fits
This is a direct-fit replacement brake caliper for the 2004-2007 Toyota Highlander, on the rear left side.
Specifications
Fit and size
- Position: Rear left
- Quantity per vehicle: 1
- Piston diameter: 38 mm (1.496 in)
- Inlet port thread: M10-1.0 x 23.4 mm
- Bleeder screw thread: M7-1.0
Build and materials
- Type: Floating
- Condition: Remanufactured
- Housing material: Cast iron
- Piston material: Steel
- Finish: Rust preventative
- Housing cast number: 3849
- Bracket cast number: 4107
- Country of origin: Mexico
In the box
One caliper with its mounting bracket, slides, dust boots, bleeder screw, crush washer and caliper and pad hardware. Pads, wear sensors, anti-squeal shims, the bleeder screw cap and the bracket mounting bolts are not included, so plan on new bolts, since the old ones may not be reusable. This listing holds one caliper for the rear left, which takes one; the rear right is a separate part ordered on its own.
Frequently Asked Questions
Is this a brake caliper replacement for the 2004-2007 Toyota Highlander rear left?
Yes. Nugeon 99-01674B is the rear left brake caliper for the 2004-2007 Toyota Highlander, and the years alone decide the fit.
Does this Nugeon caliper come with brake pads?
No. Nugeon 99-01674B comes with the bracket, slides, dust boots, bleeder screw, crush washer and hardware, but not pads, wear sensors, shims or bracket mounting bolts.
What piston size does this disc brake caliper have?
Nugeon 99-01674B has one steel piston, 38 mm (1.496 in) in diameter, in a floating caliper.
What are signs a rear left caliper is sticking?
A pull to one side under braking, a burning smell after a drive or one pad wearing faster than the other can mean a caliper is sticking. A shop can confirm it.
What thread sizes do the banjo inlet and bleeder screw use?
The banjo bolt inlet port is M10-1.0 x 23.4 mm, and the bleeder screw is M7-1.0.
