Nugeon 99-02863A front right brake caliper for the 2016-2019 Mercedes-Benz GLE400 and other vehicles clamps the brake pads against the rotor to slow the wheel. This remanufactured Nugeon brake caliper is a floating unit with two pistons.
A pull to one side under braking, a wheel that drags or fluid around the dust boots can come from a caliper. Hoses and pads can give similar signs, so find the cause before replacing it. With the engine off and the wheel removed for a brake service, look at the piston boots for wet fluid or tears.
This front right brake caliper also fits the 2017-2019 Mercedes-Benz GLS450 and the 2016-2018 Mercedes-Benz GLE350, along with other Mercedes-Benz models. The 2017-2019 Mercedes-Benz GLS450 takes one of these at the front right. If your Mercedes-Benz is not named here, open the "Vehicles it fits" section to check your exact model and engine. This listing is one caliper; the front left is a separate part, and the two calipers on the front axle are normally done at the same time.
Fit and size
Build and materials
One brake caliper with its bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw and crush washer. Brake pads, anti-squeal shims, wear sensors, the bleeder screw cap, bracket mounting bolts and the mounting bolt are not included; plan on new bolts, since the old ones may not be reusable.
Will the Nugeon 99-02863A fit a 2016-2019 Mercedes-Benz GLE400 on the front right?
Yes, Nugeon 99-02863A is a front right brake caliper for the 2016-2019 Mercedes-Benz GLE400, and it also fits the 2017-2019 Mercedes-Benz GLS450.
Does the Nugeon caliper come with brake pads and the bracket?
Yes for the bracket, no for the pads. Nugeon 99-02863A also includes the slides, dust boots, hardware, bleeder screw and crush washer; shims, wear sensors and bracket mounting bolts are not included.
Is this disc brake caliper floating, and how many pistons does it have?
Yes, it is a floating caliper. It has two phenolic pistons of 48 mm (1.89 in) diameter in an aluminum casting.
What thread does the bleeder screw on this front right brake caliper take?
The bleeder screw is M10-1.0, and the inlet port is also M10-1.0. The bleeder screw is included; the bleeder screw cap is not.
Which casting numbers are on this remanufactured brake caliper?
The housing casting number is 4896 RH and the bracket casting number is 0328 GJS. Nugeon 99-02863A is a remanufactured front right caliper made in Mexico.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
