Nugeon 99-05425B rear left brake caliper for the 2010-2012 Land Rover Range Rover and other vehicles squeezes the brake pads against the rotor to slow the wheel. This remanufactured caliper replaces a worn or leaking one at the rear left wheel.
A worn rotor, a sticking pad or a damaged brake hose can be behind a rear wheel that drags or a pull to one side, and so can a failing caliper, so find the cause before buying. Uneven rear pad wear or brake fluid around the piston boot can also come from the caliper. Both rear calipers are normally replaced together, and this Nugeon caliper is one of them, for the left side.
This caliper is a direct-fit replacement for the 2010-2012 Land Rover Range Rover, the 2010-2012 Land Rover Range Rover Sport and the 2010-2012 Land Rover LR4.
Fit and size
Build and materials
One rear left caliper with its bleeder screw and crush washers. This listing holds one caliper, the rear left takes one, and the rear right is ordered separately. Brake pads, anti-squeal shims, wear sensors, the bleeder screw cap, caliper and pad hardware and the bracket mounting bolts are not included; plan on new bracket bolts, since the old ones may not be reusable.
Is this one of the Range Rover calipers for the 2010-2012 Land Rover Range Rover?
Yes, Nugeon 99-05425B is the rear left caliper for the 2010-2012 Land Rover Range Rover; the rear right is a separate part.
What comes with the Nugeon brake caliper 99-05425B?
Nugeon 99-05425B comes with the mounting bracket, caliper slides, dust boots, bleeder screw and crush washers. Brake pads, shims, wear sensors and bracket bolts are not included.
What piston size does this disc brake caliper have?
This rear left caliper has one steel piston that measures 45 mm (1.772 in) across. It is a floating design with an aluminum casting.
How would I notice the rear left caliper on my car is sticking?
A pull toward one side when braking, a dragging feel from the rear or a burning smell at that wheel can mean a sticking caliper. A shop can test the brakes.
What thread does the inlet on the Nugeon 99-05425B use?
The inlet takes a banjo bolt with an M10-1.0 thread. The bleeder screw is also M10-1.0.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
