Nugeon 99-09107A rear right brake caliper for the 1986-1998 Saab 9000 and other vehicles clamps the brake pads against the rotor to slow the wheel. This remanufactured Nugeon brake caliper, also called a disc brake caliper, is a floating type.
A car that pulls to one side when braking, fluid around the caliper or one pad wearing faster than the other can point to a caliper problem. Before you replace the caliper, rule out worn pads, a damaged brake hose and seized caliper slides, because those can cause similar signs.
It is a direct-fit replacement for the 1986-1998 Saab 9000, and the same brake caliper fits the 1988-1994 Saab 900. This listing is one caliper for the rear right; the rear left is a separate part, and that axle is normally done on both sides at the same time. The rear right position of the 1986-1998 Saab 9000 takes one caliper.
Fit and size
Build and materials
One brake caliper with its bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw and crush washers. Brake pads, anti-squeal shims, wear sensors, a bleeder screw cap, the bracket mounting bolts and the mounting bolt are not included; plan on new bolts, since the old ones may not be reusable.
Is this the right rear caliper for the 1986-1998 Saab 9000?
Yes. Nugeon 99-09107A is the rear right brake caliper for the 1986-1998 Saab 9000. The rear left side is a separate part.
Does the Nugeon caliper come with the bracket and slides?
Yes. Nugeon 99-09107A includes the bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw and crush washers. Pads and mounting bolts are not included.
How big is the piston in this floating brake caliper?
This rear brake caliper has one steel piston that measures 32.92 mm (1.3 in) across. The housing is cast iron with a rust preventative finish.
What can a failing rear right brake caliper look like?
Brake fluid at the caliper, pulling to one side when you brake, or one pad wearing faster than the other can mean a caliper problem. A shop can test the brake hydraulics.
What bleeder screw thread does this remanufactured caliper use?
The bleeder screw is M7-1.0, and the inlet port is M10-1.0 for a line fitting. Nugeon 99-09107A includes the bleeder screw but not the bleeder screw cap.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
