Nugeon 99-09342B rear right brake caliper for the 2004-2013 Mazda 3 and other vehicles presses the brake pads against the rotor to slow the wheel. This remanufactured Nugeon brake caliper takes hydraulic pressure from the brake line and pushes its piston outward.
A caliper, also sold as a disc brake caliper, can show wear as a brake that drags, a pull to one side while braking, or brake fluid around the wheel. These signs alone do not prove the caliper is at fault, since a collapsed brake hose can also hold a brake on.
It works as a rear caliper for the 2004-2013 Mazda 3, and the vehicles it fits also include the 2010-2013 Mazda 3 Sport and the 2007-2013 Volvo C30. If your car is not named here, look up its year and model in the "Vehicles it fits" section. This listing is one caliper for the rear right; the rear left is a separate part, and the calipers on that axle are normally replaced together.
Fit and size
Build and materials
One caliper with its mounting bracket, slides, dust boots, bleeder screw, crush washers, mounting hardware and caliper and pad hardware. Brake pads, anti-squeal shims, the bleeder screw cap, wear sensors, a grease pack, the bracket bolts and the mounting bolt are not included, and the old bolts may not be reusable, so plan on new ones. This listing holds one caliper, and the rear right takes one.
Interchange / FMSI:
FMSI: D973
Does this Mazda 3 brake caliper fit a 2004-2013 Mazda 3?
Yes. Nugeon 99-09342B is the rear right caliper for the 2004-2013 Mazda 3, whatever the engine. For another model, look up your car in the "Vehicles it fits" section.
Does this Mazda 3 rear brake caliper also fit the 2010-2013 Mazda 3 Sport?
Yes. Nugeon 99-09342B is also listed for the 2010-2013 Mazda 3 Sport as the rear right caliper, and that side takes one.
Does the Nugeon caliper come with the bracket and brake pads?
Yes to the bracket, no to the pads. The mounting bracket, slides and dust boots come with it, but brake pads, shims and the bracket bolts are not included.
What piston size and inlet thread does this rear right caliper have?
The single steel piston is 38 mm (1.49 in) across, and the line inlet uses an M10-1.0 thread.
Is the bleeder screw included on this remanufactured caliper?
Yes. The M10-1.0 bleeder screw (M10-1.0 x 28.8 mm thread) is included, but the bleeder screw cap is not.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
