Nugeon Disc Brake Caliper P/N:99-01416B
Nugeon 99-17281B rear left brake caliper for the 1994-1996 Chevrolet Impala and other vehicles slows the wheel by squeezing the brake pads against the rotor. This remanufactured Nugeon brake caliper takes hydraulic pressure from the brake line to apply that force.
A car that pulls to one side under braking, a fluid leak around the caliper or pads that wear unevenly can mean this caliper is worn, though a collapsed brake hose or a damaged rotor can produce some of the same signs, so find the cause before replacing it.
It fits the 1994-1996 Chevrolet Impala and the 1994-1996 Chevrolet Caprice. Calipers are best replaced in pairs across an axle, and this listing is one rear left caliper; the rear right is a separate part.
Fit and size
Build and materials
One rear left caliper with its mounting bracket, caliper slides, dust boots, bleeder screw, banjo bolt and crush washer. This listing holds one caliper, and the rear left side of the car takes one. Brake pads, anti-squeal shims, wear sensors, the bleeder screw cap, caliper and pad hardware and the bracket mounting bolts are not included, so plan on new bracket mounting bolts.
Is this rear left caliper the one for a 1994-1996 Chevrolet Caprice?
Yes. Nugeon 99-17281B fits the 1994-1996 Chevrolet Caprice as well as the 1994-1996 Chevrolet Impala, for the rear left position, one per application.
Does the Nugeon caliper come with brake pads?
No. Nugeon 99-17281B is one remanufactured rear left caliper with its bracket, slides, dust boots, bleeder screw, banjo bolt and crush washer; brake pads are sold separately.
Is this disc brake caliper a floating or fixed type?
This rear left caliper is a floating type with one steel piston, 54 mm (2.126 in) across.
What does a sticking rear left caliper do to braking?
A caliper that sticks can drag a pad against the rotor, which may show up as pulling, heat or uneven pad wear. A shop can test the caliper and its slides.
What thread does the banjo bolt inlet on this caliper use?
The inlet port is M10-1.0 x 27.32 mm with a banjo bolt fitting, and the bleeder screw is M10-1.0.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.