Nugeon 99-17345A rear right brake caliper for the 2004-2012 Chevrolet Malibu and other vehicles squeezes the pads against the rotor to slow the wheel. This Nugeon brake caliper is remanufactured, and hydraulic pressure pushes its piston to apply the pads.
- Floating caliper with a single steel piston, 38 mm in diameter
- Aluminum caliper casting with a rust-preventative finish
- Banjo inlet fitting with an M10-1.5 inlet thread
- Bleeder screw with an M10-1.0 thread
Quick facts
- Part: Nugeon 99-17345A brake caliper
- Also called: disc brake caliper
- Fits: 2004-2012 Chevrolet Malibu and other vehicles
- Position: Rear right
- Material: Aluminum
- Condition: Remanufactured
A caliper that is failing can show up as the car pulling to one side, brake fluid around the caliper or a wheel that drags and runs noisy. A stuck slide or piston can cause these, and so can worn pads or a damaged rotor, so look for the cause during a brake service before replacing the caliper.
Fits
It is listed for a wide range of Chevrolet, Pontiac and Saturn models, including the 2004-2012 Chevrolet Malibu and the 2008-2010 Chevrolet HHR, and as a brake caliper for the 2007-2010 Pontiac G5. If your car is not named here, look up its year and model in the "Vehicles it fits" section. This listing is one caliper for the rear right; the rear left is a separate part, and the two rear calipers are normally replaced together.
Specifications
Fit and size
- Position: Rear right
- Quantity for this position: 1
- Piston outside diameter: 37.97 mm (1.5 in)
- Piston diameter: 38 mm (1.496 in)
- Inlet: banjo fitting, M10-1.5 thread; inlet port thread M10-1.5 x 23.14 mm
- Bleeder screw thread: M10-1.0
- Housing cast number: B3815
Build and materials
- Caliper type: Floating
- Casting material: Aluminum
- Piston material: Steel
- Finish: Rust preventative
- Condition: Remanufactured
- Country of origin: Mexico
In the box
One remanufactured rear right brake caliper with its bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw, banjo bolt and crush washers. Brake pads, anti-squeal shims, wear sensors, a bleeder screw cap, the bracket mounting bolts and the mounting bolt are not included, so plan on new bolts. The rear right takes one caliper.
Frequently Asked Questions
Is this the right Chevy Malibu brake caliper for a 2004-2012 Chevrolet Malibu?
Yes. Nugeon 99-17345A is the rear right caliper for the 2004-2012 Chevrolet Malibu. For other years and models, look up your car in the "Vehicles it fits" section.
Is this an HHR brake caliper for the 2008-2010 Chevrolet HHR?
Yes. Nugeon 99-17345A is listed for the 2008-2010 Chevrolet HHR as the rear right caliper, and that side takes one.
Does this disc brake caliper come with brake pads?
No. This rear right caliper comes with its bracket, slides, dust boots, hardware, bleeder screw, banjo bolt and crush washers. Pads, anti-squeal shims and wear sensors are not included.
What happens when a rear brake caliper sticks?
It can leave the wheel hot with a burning smell after a drive, or wear one pad faster than the other. Have it checked promptly, since a shop can test the caliper.
Which bleeder screw thread does the Nugeon caliper use?
The bleeder screw is M10-1.0 and is included with the caliper. The bleeder screw cap is not included.
