Nugeon Disc Brake Caliper P/N:99-01189B
Nugeon 99-17490A front left brake caliper for the 2016-2019 Chevrolet Cruze and other vehicles clamps the pads against the rotor to slow the wheel. This remanufactured Nugeon brake caliper uses hydraulic pressure to push its piston against the pad.
A sticking or leaking disc brake caliper can show up as the car pulling to one side when you brake, pads that wear unevenly, or fluid around the dust boot. Brake hoses and other brake parts can produce similar signs, so find the cause first: with the engine off and the brakes cool, look at the dust boot for wetness before you replace the caliper.
The vehicles it fits include the 2016-2019 Chevrolet Cruze, the 2022-2023 Chevrolet Bolt EUV and the 2017-2023 Chevrolet Bolt EV, and each takes one caliper at the front left. This listing is one caliper; the front right is a separate part, and the two on that axle are normally replaced at the same time.
Fit and size
Build and materials
One remanufactured brake caliper with its bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw with cap and crush washers. Brake pads, anti-squeal shims, wear sensors and bracket mounting bolts are not included, so plan on new mounting bolts, since the old ones may not be reusable.
Interchange / FMSI:
FMSI: D1844
Product information is for general reference and may contain errors. See our Disclaimer.
Will this Chevy Cruze brake caliper fit the 2016-2019 Chevrolet Cruze front left?
Yes. Nugeon 99-17490A is a front left caliper for the 2016-2019 Chevrolet Cruze. If your car is a different one, find it in the "Vehicles it fits" section on this product page.
Does the Nugeon caliper come with brake pads?
No. Nugeon 99-17490A does not include brake pads, anti-squeal shims, wear sensors or bracket mounting bolts. It does include the bracket, slides, dust boots, hardware and bleeder screw.
What piston size and bleeder thread does this front left caliper have?
The caliper has one phenolic piston, 60 mm (2.36 in) across, and an M10-1.0 bleeder screw. The inlet is a banjo bolt fitting with an M10 - 1.5 thread.
How can I tell if a caliper is leaking or sticking?
Wet fluid near the dust boot, unevenly worn pads, or pulling to one side when you brake can be signs of a sticking or leaking caliper. Have a shop check the brakes promptly rather than driving on them.
Is this remanufactured caliper body cast iron?
Yes. The caliper body is cast iron with a rust-preventative finish, and the piston is phenolic. Country of origin: Mexico.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.