Nugeon 99-17779B front right brake caliper for the 2012-2020 Dodge Journey clamps the pads against the rotor to slow the wheel. This remanufactured Nugeon brake caliper replaces a worn, sticking or leaking one at the front right wheel.
A pull to one side under braking, pads that wear unevenly or damp fluid around the dust boot can mean a sticking or leaking caliper. With the car parked and the brakes cool, and the wheel off for brake service, look at the boot and the hose fitting for tears or wetness. Pads, the rotor or the brake hose can cause similar signs, so find the cause before you replace the caliper.
This front right caliper is a direct-fit replacement for the 2012-2020 Dodge Journey.
Fit and size
Build and materials
One front right caliper with its mounting bracket, caliper slides, dust boots, bleeder screw and cap, crush washers, and caliper and pad hardware. Brake pads, anti-squeal shims, wear sensors and bracket mounting bolts are not included, so plan on new bolts rather than reusing the old ones. This listing is one caliper and this side takes one; the front left is a separate part, and the two are normally replaced together.
Interchange / FMSI:
FMSI: D1589
Is this the right brake caliper for the 2012-2020 Dodge Journey?
Yes. Nugeon 99-17779B is the front right caliper for the 2012-2020 Dodge Journey. The front left side takes a separate caliper.
Does this Nugeon caliper come with brake pads?
No. Nugeon 99-17779B includes the bracket, slides, dust boots, bleeder screw and cap, and hardware. Brake pads, anti-squeal shims and wear sensors are not included.
How big are the pistons in this front right caliper?
This front right brake caliper has two phenolic pistons, each 51 mm (2.00 in) in outside diameter, in a floating cast-iron body.
How can I spot a sticking front right disc brake caliper?
A burning smell after a drive, a brake that drags or fluid on the inside of the wheel can mean a caliper problem, though other brake parts cause similar signs. Have a leak or dragging brake looked at promptly.
What thread size is the inlet port on this caliper?
The inlet port is M10-1.0 x 23.4 mm and takes a banjo bolt fitting. The bleeder screw on this caliper is also M10-1.0.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
