Nugeon 99-18027B rear left brake caliper for the 2017-2019 Ford Escape and other vehicles squeezes the brake pads against the rotor to slow the wheel. This remanufactured disc brake caliper takes the place of a worn or leaking one on the rear left wheel.
Worn pads or a worn rotor can be behind a pull to one side when you brake or a burning smell after a drive, just as a sticking caliper can, so find the cause before you buy one. Fluid around the rear wheel can mean a caliper is leaking.
This rear left brake caliper is a floating type that fits the 2013-2020 Ford Fusion and the 2015-2023 Ford Edge, along with many other Ford and Lincoln vehicles. If your car is not named here, open the "Vehicles it fits" section and look up your exact model and engine.
Replacing both rear calipers together is the usual practice. This listing is one caliper for the rear left, since each side of the rear axle takes its own, and the rear right is ordered separately.
Fit and size
Build and materials
One remanufactured brake caliper with its mounting bracket, caliper slides, dust boots, caliper and pad hardware, mounting hardware, a bleeder screw with cap and crush washers. Brake pads, wear sensors, anti-squeal shims and mounting bolts are not included, so plan on new bolts, as the old ones may not be reusable.
Interchange / FMSI:
FMSI: D1665
Does Nugeon 99-18027B work as a Ford Fusion brake caliper for 2013-2020 models?
Yes. Nugeon 99-18027B is listed for the 2013-2020 Ford Fusion as the rear left caliper. The rear right side is a separate part.
Is this a Ford Escape brake caliper for the 2017-2019 model years?
Yes. This rear left caliper is listed for the 2017-2019 Ford Escape. For another model or engine, open the "Vehicles it fits" section and check your own car.
Does this Nugeon caliper come with the bracket and slides, or only the caliper body?
Yes. The Nugeon 99-18027B includes the mounting bracket, caliper slides, dust boots, caliper and pad hardware and a bleeder screw with cap. Pads, wear sensors and mounting bolts are not included.
What are the piston diameter and inlet thread on this rear left caliper?
The piston is steel with a 38 mm (1.50 in) outside diameter, and there is one piston. The banjo bolt inlet has an M10-1.0 x 23.4 mm port thread.
Do I need to buy new mounting bolts for this remanufactured caliper?
Yes, plan on new ones. Neither the bracket mounting bolts nor the caliper mounting bolt are included, and the old bolts may not be reusable.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
