TERREPOWER 99P17762B front brake caliper for the 2012-2023 Dodge Charger and other vehicles clamps the brake pads against the rotor to slow the wheel. This remanufactured disc brake caliper fits either front side.
Pulling to one side under braking, uneven pad wear or fluid around the caliper can mean a front caliper is sticking or leaking, though a worn brake hose or worn pads can sit behind the same signs, so find the cause before you replace it.
This floating front brake caliper also fits the 2012-2023 Chrysler 300 and the 2012-2023 Dodge Challenger as a direct-fit replacement. Open the "Vehicles it fits" section to check your exact model and engine.
Fit and size
Build and materials
One remanufactured brake caliper with its mounting bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw and crush washers. This listing holds one caliper and each front wheel takes one, so a pair means ordering two, and both front sides are normally replaced together. Brake pads, anti-squeal shims, bracket mounting bolts, a bleeder screw cap, wear sensors and a grease pack are not included, so plan on new bolts rather than reusing the old ones.
Interchange / FMSI:
FMSI: D1058
Is this a brake caliper for the 2012-2023 Dodge Charger?
Yes, TERREPOWER 99P17762B fits the front left or front right of the 2012-2023 Dodge Charger. Open the "Vehicles it fits" section to check your exact engine.
Can I use it as a brake caliper for the 2012-2023 Dodge Challenger?
Yes. The 2012-2023 Dodge Challenger is listed for either front side, with one caliper per side.
Does the TERREPOWER 99P17762B caliper come with pads or bracket bolts?
No, pads and bracket mounting bolts are not included. The caliper comes with its bracket, slides, dust boots, hardware, bleeder screw and crush washers; anti-squeal shims, wear sensors and a grease pack are also not included.
How many pistons does this remanufactured caliper have, and how big are they?
TERREPOWER 99P17762B is a floating caliper with two phenolic pistons, each 42 mm (1.65 in) in outside diameter.
What thread sizes do the inlet and bleeder screw use on this caliper?
The banjo inlet port is M10-1.5 x 26.92 mm, and the bleeder screw is M10-1.5. A bleeder screw comes with the caliper.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
