PowerStop Disc Brake Caliper P/N:L2796
PowerStop L4941 rear right brake caliper for the 2005 Chevrolet Silverado 1500 and other vehicles squeezes the brake pads against the rotor to slow the wheel. PowerStop brake calipers like this one are sold individually.
A disc brake caliper that sticks or leaks can show up as the vehicle pulling to one side when braking, a burning smell after a drive, or brake fluid near the wheel. These signs alone do not prove the caliper is at fault; uneven tire pressure can pull a vehicle to one side too.
It also works as a brake caliper for the 2005 GMC Sierra 1500 and the 2002-2006 Chevrolet Tahoe, and each takes one at the rear right. This listing is one caliper; the rear left is a separate part, and that axle is normally done at the same time. If your truck, SUV or van is not one of these, look up your year and model in the "Vehicles it fits" section.
Fit and size
Build and materials
One rear right brake caliper with caliper slides (guide pins), new seals, dust boots and a bleeder screw. Brake pads, mounting bracket, mounting bolts, mounting hardware and caliper grease are not included, so plan on new bolts, since the old ones may not be reusable.
Product information is for general reference and may contain errors. See our Disclaimer.
Is L4941 the correct Tahoe brake caliper for the rear right of a 2002-2006 Chevrolet Tahoe?
Yes. PowerStop L4941 is listed for the 2002-2006 Chevrolet Tahoe in the rear right position, one per vehicle for that position. Use the "Vehicles it fits" section if you drive something else.
Is this PowerStop L4941 a Chevrolet Silverado 1500 brake caliper for the 2005 model year?
Yes. PowerStop L4941 is listed for the 2005 Chevrolet Silverado 1500 at the rear right, one per vehicle for that position; the rear left is a separate caliper.
Does the PowerStop L4941 come with brake pads or a mounting bracket?
No. This listing is the caliper only, with guide pins, seals, dust boots and a bleeder screw. Pads, bracket, mounting bolts, mounting hardware and caliper grease are not included.
What are the pistons in this rear caliper made of?
This caliper has two phenolic pistons in a floating design with an aluminum casting. The piston diameter is 44.96 mm.
How can I tell a rear brake caliper may be failing?
Signs can include pulling to one side under braking, a burning smell after driving, or brake fluid near the wheel. Have a leaking or dragging caliper checked or replaced promptly.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.