Bring back tight, responsive steering with the QuickSteer Suspension Ball Joint K500129. This front lower ball joint installs as a direct-fit replacement for the 2003-2007 Nissan Murano, 2004-2009 Nissan Quest, and 2008-2020 Nissan Rogue — see the Buyer's Guide tab for the engine-level applications. QuickSteer chassis parts are designed and tested to help restore steering and handling toward their original performance, and this joint is built for OE fit and function.
Heavy-duty gauge steel construction with ball studs heat treated to match or exceed OE requirements to inhibit premature failure and improve fatigue strength.
Gusher bearing: a metal-to-metal design that adds strength and lets grease flow through the bearing surface for reduced friction.
Greaseable socket allows new lubricant to flush contaminants, helping reduce corrosion and wear; a Belleville preload washer helps keep the bearing package tight as bearings wear.
Premium boot and a pressed-in cover plate help seal out debris and contaminants.
Precision tolerances are intended for easy installation and steering alignment. If a worn front lower ball joint is behind your loose steering, clunking, or uneven tire wear, this replaces it. Sold individually — for even wear, it's best practice to replace the matching joint on the other side as a pair.
Frequently Asked Questions
What vehicles does the K500129 ball joint fit?
It's a direct-fit replacement for the 2003-2007 Nissan Murano, 2004-2009 Nissan Quest, and 2008-2020 Nissan Rogue. See the Buyer's Guide tab for the full engine-level applications.
Is this a front or rear ball joint?
It's cataloged as a front lower suspension ball joint for the listed Nissan applications.
Is this ball joint greaseable?
Yes. It has a greaseable socket that allows new lubricant to flush contaminants, helping reduce corrosion and wear.
What are the signs my ball joint may need replacing?
Common signs include loose or wandering steering, clunking or knocking over bumps, and uneven front tire wear. Diagnose the cause before replacing.
Should I replace both ball joints at once?
This listing is for one ball joint, sold individually. For even wear and balanced handling, it's best practice to replace the matching joint on the other side at the same time.
Keep your steering tight and your front suspension planted with the MOOG K7365 Front Lower Suspension Ball Joint. This front lower ball joint drops in as a direct-fit replacement for the 2000-2001...
Keep the front suspension tight and steering responsive with the MOOG K6541 Front Lower Suspension Ball Joint (also cataloged as QuickSteer K6541). This QuickSteer/MOOG chassis part is a front lower...
QuickSteer K8194T Suspension Ball Joint for Chevrolet K10MOOG K8194T Front Upper Suspension Ball Joint for Chevrolet K10Front Upper Suspension Ball JointQuickSteer™ chassis parts are designed and...
Tighten up front steering and handling and keep the suspension properly located with the QuickSteer Suspension Ball Joint K80281. This front lower ball joint is designed for OE fit and function and...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
