QuickSteer Suspension Stabilizer Bar Link P/N:K80244
Tighten up steering response and quiet a rattling sway bar with the QuickSteer / MOOG Front Suspension Stabilizer Bar Link K80337. It installs at the front stabilizer bar as a direct-fit replacement for the 2005-2008 Ford F-150 and the 2006-2008 Lincoln Mark LT — see the Buyer's Guide tab for the full engine-level fitment. This link connects the front stabilizer (sway) bar to the suspension so the bar can resist body roll; when the original link's joints wear out you get looseness, clunks over bumps, and reduced handling that replacing it addresses.
Designed for OE fit and function, this QuickSteer link helps restore front suspension and handling performance on the listed applications.
What does this stabilizer bar link do?
It connects the front stabilizer (sway) bar to the suspension, letting the bar resist body roll. Worn links cause looseness and clunks that replacing the link addresses.
Which vehicles does the K80337 fit?
It's a front stabilizer bar link for the 2005-2008 Ford F-150 and the 2006-2008 Lincoln Mark LT. Check the Buyer's Guide tab to confirm fitment for your vehicle.
Is this a front or rear link?
This is a front suspension stabilizer bar link for the listed applications.
Can the socket be greased?
Yes. It features a greaseable socket that lets you add fresh lubricant to flush out contaminants, helping reduce corrosion and wear.
Are the links sold as a pair?
This listing is for one stabilizer bar link. Vehicles typically use a link on each side, so inspect and replace as needed for balanced handling.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.