Route brake fluid from the hard line to the caliper with the Raybestos Element3 Brake Hydraulic Hose (BH38664). It's cataloged for the front left position and drops in on a wide range of GM trucks and SUVs, including the 1988-1999 Chevrolet K1500, 1995-2000 Chevrolet Tahoe, and 1992-2000 GMC Yukon — see the Buyer's Guide tab for the full list of vehicles.
This hose measures 18.5 inches overall, with a female SAE-thread fitting on one end and a banjo fitting on the other. The required gasket/seal is included, along with washers and accessories where applicable. A flexible hydraulic hose carries pressurized brake fluid to the caliper while allowing for suspension travel and steering movement. If a cracked, leaking, or deteriorated original hose is the cause of a spongy pedal, this replaces it.
Where does the BH38664 install?
It's cataloged for the front left position on the listed GM truck and SUV applications.
What fittings does this hose use?
One end uses a female SAE thread and the other is a banjo fitting. The required gasket/seal is included, plus washers and accessories where applicable.
How long is the hose?
The overall hose length is 18.5 inches.
Is this hose pressure tested?
Yes—each hose is 100% end-of-line pressure tested and built to meet Federal and SAE standards for performance and safety.
What are signs a brake hose may need replacing?
Cracked, bulging, or chafed outer covering, fluid weeping at the fittings, or a soft, spongy pedal can be signs. If a failing hose is the cause, this replaces it—diagnose the cause first.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
