Help keep lubricant in and road dirt and water out with the SKF wheel seal 20455. This wheel seal / drive axle shaft seal is listed under both names. It is a direct-fit replacement for many vehicles, among them the 1984-1987 Toyota Corolla, 1983-1991 Toyota Camry and 1985 Honda Civic.
The seal body stays stationary while its lip rides against the turning shaft. This holds lubricant in and keeps contaminants out. It is cataloged for the front, front outer, front inner, rear outer and rear inner positions, depending on the application.
SKF invented the first integrated shaft seal in 1928. Since then it has kept developing new seal designs and bonding techniques. Its seals are built to specific designs from premium materials, chosen so each seal suits both its application and its operating environment.
Signs this seal may need replacing include lubricant seeping past the seal or a wet, grimy buildup around it. Diagnose the source of any leak before replacing parts. See the "Vehicles it fits" section for complete application details.
Interchange: 052-3621 · CHR 20455 · 91262SD9-003 · 91262SD9-004 · 52X68X7.5-12S-1-CRSA · 52X68X8-14S-HMSA · B210-33-065 · 04422-20020
0523621 · CHR20455 · 91262SD9003 · 91262SD9004 · 52X68X7512S1CRSA · 52X68X814SHMSA · B21033065 · 0442220020 · 4023221B00 · 975920455 · BD1694E · 145820455 · 20455CHR · N20455 · 67246
This part cross-references / interchanges with the following part numbers:
What does the SKF wheel seal 20455 do?
Its stationary body holds a sealing lip against the rotating shaft. This keeps lubricant in and keeps contaminants such as dirt and water out.
Which vehicles does this seal fit?
It fits many vehicles, among them the 1984-1987 Toyota Corolla, 1983-1991 Toyota Camry and 1985 Honda Civic. See the "Vehicles it fits" section for the full list.
What position does this seal install in?
It is cataloged for the front, front outer, front inner, rear outer and rear inner positions, depending on the vehicle. The "Vehicles it fits" section shows the application details.
How is this seal constructed?
The body is deep drawn sheet steel, forming a rigid, stress-resistant metal case. The garter springs use cold drawn steel wire for fluid retention.
What are signs a wheel seal may need replacing?
Lubricant seeping past the seal or a wet, grimy buildup around it can signal a worn seal. Diagnose the source of the leak before replacing parts.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
