SKF Transfer Case Output Shaft Seal P/N:21061
Keep lubricant sealed in and road grime out with the SKF transfer case output shaft seal, part number 13761A. This rear-position seal fits many Subaru models, among them the 1998-2014 Subaru Forester, 2000-2014 Subaru Outback and 1993-2014 Subaru Impreza; see the "Vehicles it fits" section for the full list and engine details.
The seal's body stays stationary in its bore while its lip rides on the rotating output shaft. It holds lubricant in the transfer case and helps keep contaminants from getting past the shaft.
SKF introduced the first integrated shaft seal in 1928. The company has continued to develop new seal designs and bonding techniques, and it builds its seals to specific designs with materials chosen for each application and its environment.
Signs this seal may need replacing: fluid seeping or dripping at the rear of the transfer case, an oily film around the output shaft area, or a lubricant level that keeps dropping. Diagnose the leak source before replacing.
Interchange: E003 · 710324 · AH2060H · 806735210
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What does the SKF 13761A seal do?
It seals the rear output shaft of the transfer case. The body stays stationary while the lip rides on the spinning shaft, which keeps lubricant in and helps keep dirt and water out.
Which vehicles does the SKF 13761A fit?
It is listed for many Subaru models, among them the 1998-2014 Subaru Forester, 2000-2014 Subaru Outback and 1993-2014 Subaru Impreza. See the "Vehicles it fits" section for the full list.
What are signs of a leaking transfer case output shaft seal?
Common signs are fluid seeping at the rear of the transfer case, oily residue around the output shaft, or a falling lubricant level. Other seals can leak too, so confirm the source first.
What is the seal's case made of?
SKF forms the body from deep drawn sheet steel for a rigid, stress-resistant metal case. The garter spring uses cold drawn steel wire.
What part numbers does SKF 13761A interchange with?
SKF 13761A interchanges with E003, 710324, AH2060H and 806735210.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.