Keep power flowing from transmission to axle with the SKF Brute Force Universal Joint UJ285, a greasable, pre-lubricated U-joint built to connect and articulate rotating driveshaft sections. It's a direct-fit replacement across a wide range of Toyota and Lexus trucks and SUVs, including the 1979-1995 Toyota Pickup, 1984-2019 Toyota 4Runner, 1995-2004 Toyota Tacoma, 2000-2006 Toyota Tundra, 1991-2011 and 2013-2016 Toyota Land Cruiser, 2007-2014 Toyota FJ Cruiser, 2003-2009 Lexus GX470 and 2010-2019 Lexus GX460 — see the Buyer's Guide tab for the full list. The catalog lists this joint in front, rear, and center driveshaft positions, so confirm the correct location for your vehicle.
- Thrust washers: eliminate metal-to-metal contact, prevent wear, and lower the overall operating temperature.
- Black oxide coating: superior rust protection for extended life in corrosive conditions.
- Forged construction: hardened alloy steel cross, forged steel caps that are case-hardened and precision ground, and thru-hardened high-carbon steel needle bearings for load-carrying capability.
- Nitrile rubber cap seals + grease: retain grease and exclude contaminants; pre-lubricated with premium high-temperature grease and greasable for service.
Interchange: 1-1612BF
11612BF · 45U0165 · 285
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What does this universal joint do?
It connects and transmits torque between rotating driveshaft sections while allowing them to operate at an angle, keeping power flowing from the transmission to the axle.
Is the UJ285 greasable?
Yes. It arrives pre-lubricated with premium high-temperature grease and is a greasable design, so it can be serviced with grease during maintenance.
What are signs this U-joint may need replacing?
Clunking on acceleration or shifting, a vibration that grows with speed, or a squeaking noise from the driveline are common signs. Diagnose the cause before replacing.
What position does this joint fit?
The catalog lists it in front, rear, and center driveshaft positions depending on the application. Confirm the correct location for your vehicle before ordering.
How is the UJ285 built for durability?
It uses a forged hardened alloy steel cross, case-hardened precision-ground caps, thru-hardened high-carbon steel needle bearings, and a black oxide coating for rust protection.
Write a Review