Help bring back steady steering and control with the SKP Control Arm with Ball Joint SRK620262, a front right upper Dodge Durango control arm for 1998-1999 models that also fits the 1997-1999 Dodge Dakota. It is a direct-fit replacement for the listed applications. For engine details, see the "Vehicles it fits" section.
This SKP control arm pairs the arm with a ball joint that is already installed, so there is no separate joint to fit during the repair. If a worn arm or ball joint is causing loose handling, clunks or a rough ride, this assembly replaces both parts in one piece.
- Pre-installed ball joint: Arrives assembled with the ball joint already in place, which helps save time and simplify the job.
- Built to OE standards: Made from quality materials and designed to match or surpass OE specifications for the demands of everyday driving.
- Hardware: Installation hardware is included where pictured, so there is less to track down separately.
- Ride comfort: Worn control arms and ball joints can contribute to a bumpy ride. A new assembly is designed to help return the suspension to proper function.
This listing covers the front right upper position and is sold individually. Replacing the left and right sides together is recommended to help keep handling even, and an alignment check after installation is advised.
Interchange: 520-312
52039410AB · WC110312 · 520312 · CB81188 · CK620262 · RK620262 · CMS25103 · MS25103
This part cross-references / interchanges with the following part numbers:
52039410AB, WC110312, 520312, 520-312, CB81188, CK620262, RK620262, CMS25103, MS25103
Frequently Asked Questions
Will this control arm fit my 1997-1999 Dodge Dakota?
It is listed for the 1997-1999 Dodge Dakota and the 1998-1999 Dodge Durango in the front right upper position. See the "Vehicles it fits" section for engine details.
What does a control arm and ball joint assembly do?
The control arm connects the wheel's steering knuckle to the vehicle, and the ball joint gives it a pivot point so the wheel can move with the suspension and turn with the steering.
Is the ball joint already installed?
Yes. The ball joint comes pre-installed in the arm, which helps save time compared with fitting a separate joint. Hardware is included where pictured.
What are signs this part may need replacing?
Clunking over bumps, loose or wandering steering, uneven tire wear, or play in the ball joint can point to wear. Diagnose the cause before you replace parts.
Should I replace both sides at the same time?
This listing is for the front right upper arm only and is sold individually. Replacing both sides together is recommended to help keep handling even.
