Keep the front steering knuckle securely fastened with the Spicer Steering Knuckle Bolt 41027 from Dana Spicer Chassis. This front-position knuckle bolt is a direct-fit replacement for the 1996-2004 Jeep Grand Cherokee, 1997-2006 Jeep TJ, 1997-2006 Jeep Wrangler, and 2000-2001 Jeep Cherokee — see the "Vehicles it fits" section for engine-level details.
The steering knuckle bolt secures the front steering knuckle to its mating component, holding the joint in proper position under steering and road loads. Signs the original fastener may need attention include a loosened or improperly torqued connection found during service. Because knuckle bolts can be torque-to-yield or single-use, consult the vehicle service information for the correct fastener, torque specification, and whether it may be reused.
Product information is for general reference and may contain errors. See our Disclaimer.
What is the Spicer 41027?
It is a genuine Spicer front steering knuckle bolt from Dana Spicer Chassis, built to Dana's OE standards to secure the front steering knuckle.
Which vehicles does it fit?
It fits the 1996-2004 Jeep Grand Cherokee, 1997-2006 Jeep TJ, 1997-2006 Jeep Wrangler, and 2000-2001 Jeep Cherokee. See the "Vehicles it fits" section for engine-level details.
Is this a front or rear part?
This is a front-position steering knuckle bolt for the listed applications.
Can I reuse my old knuckle bolt?
Knuckle bolts can be torque-to-yield or single-use. Consult the vehicle service information for the correct fastener and whether it may be reused.
Is this a genuine Spicer part?
Yes. It is a genuine Spicer part, tested and validated to rigorous OE specifications set by Dana.
No reviews yet — be the first to review this product.
Write a Review
Dana
Dana
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
