Hold your hood open with steady, controlled motion using the Stabilus Hood Lift Support 5B-270827, a 14.11-inch hydraulically dampened, gas-charged lift support. It installs as a direct-fit replacement for the 2009-2017 Ford Expedition — see the "Vehicles it fits" section for the full engine breakdown. As the gas charge weakens with age, a hood that drifts down, feels heavy to raise, or won't stay up is a common sign this support may need replacing.
- Patented Labyrinth Piston: delivers clog-free, smooth operation through opening and closing.
- Clog-free design: helps prevent binding caused by contamination.
- Corrosion-resistant coatings: part coatings tested to automotive standards for corrosion resistance.
- Easy installation: based on the OE design for proper fit, form, and function, and requires no special tools.
Built on Stabilus Lift-O-Mat hydraulic damping, it uses an oil-channeling system and labyrinth piston tuned with application-specific oil viscosities and a precision seal-guide system for refined, controlled motion. For best results, replace lift supports in pairs.
Interchange: 7L1Z 16C826-A · 7L1Z 16C826-AA · 9L1Z 16C826-A · 9L1Z 16C826-B · 9L1Z 16C826-C · 819-7042
7L1Z16C826A · 7L1Z16C826AA · 9L1Z16C826A · 9L1Z16C826B · 9L1Z16C826C · E96647DL · E96647 · 8197042 · 270827 · 6647 · E6647 · SG304095 · TSG304095
This part cross-references / interchanges with the following part numbers:
LS11106, E96647DL, 7L1Z 16C826-A, 7L1Z16C826A, 7L1Z 16C826-AA, 7L1Z16C826AA, 9L1Z 16C826-A, 9L1Z16C826A, 9L1Z 16C826-B, 9L1Z16C826B, 9L1Z 16C826-C, 9L1Z16C826C, 6647, E6647, E96647, 819-7042, 8197042, 270827, SG304095, TSG304095
Frequently Asked Questions
What vehicle does this hood lift support fit?
It is a direct-fit replacement for the 2009-2017 Ford Expedition. Check the "Vehicles it fits" section to confirm the exact fit for your vehicle.
How long is this lift support?
The manufacturer lists it at 14.11 inches. It is a hydraulically dampened, gas-charged hood lift support.
Should I replace both lift supports at once?
Stabilus recommends replacing lift supports in pairs for best results, since both typically wear at a similar rate for consistent, balanced hood operation.
What are signs this hood lift support needs replacing?
A hood that drifts down, won't stay raised, or feels heavy to open can indicate the gas charge has weakened. If a worn support is the cause, this replaces it.
Do I need special tools to install it?
No. It is based on the OE design for proper fit, form, and function and is easy to install without special tools.
