Stabilus Liftgate Lift Support 3B-452693
Stabilus Liftgate Lift Support 3B-452693

Stabilus Liftgate Lift Support P/N:3B-452693

Be the first to review this product
$32.99
MPN: 3B-452693
Item Package Code: EA
Part Has Core (Y/N): N
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Ask an Expert
Stabilus Liftgate Lift Support P/N:3B-452693
Stabilus Liftgate Lift Support P/N:3B-452693
$32.99

Keep the rear hatch rising smoothly and holding open with the Stabilus Liftgate Lift Support 3B-452693, a gas-charged lift support that measures 26.65 inches. It drops in as a direct-fit replacement for the 2012-2019 Volkswagen Beetle (see the Buyer's Guide tab for engine-specific applications), reviving a tired strut that no longer holds the liftgate up or opens with control.

  • Dynamic damping speed control: gas flow is managed by a groove pressed into the tube wall for a fluid opening motion, designed to reduce bouncing and jerking.
  • Integrated lift assist: an internal mechanical compression spring compresses in the closed position to give an added boost during initial opening, helping release the application off the latch.
  • Corrosion-resistant coatings: part coatings are tested to automotive standards for corrosion resistance.
  • Easy installation: based on the OE design for proper fit, form, and function, and installs with no special tools.

This is a Lift-O-Mat by Stabilus, using a longitudinal velocity-manifold groove that gradually narrows toward the end of the stroke for a gentle, controlled stop. For best results, replace lift supports in pairs so both sides open and hold evenly.

Frequently Asked Questions

What vehicle does this lift support fit?

It is a direct-fit replacement for the 2012-2019 Volkswagen Beetle. Check the Buyer's Guide tab to confirm the application for your specific vehicle.

How long is this lift support?

The manufacturer lists this Stabilus lift support at 26.65 inches. Compare it to your original strut to confirm the correct length before ordering.

What does the internal spring do?

An internal mechanical compression spring compresses when the gate is closed to give an added boost during initial opening, helping release the application off the latch.

Should I replace both lift supports at once?

Stabilus recommends replacing lift supports in pairs for best results, so both sides open and hold the liftgate evenly. Sold individually.

Are special tools required to install it?

No. It is based on the OE design for proper fit, form, and function and installs with no special tools. Consult the vehicle service information for the correct procedure.

Related Products

!