Standard Ignition ALS933 rear right ABS wheel speed sensor for the 1988-1992 Mazda 626 and other vehicles reports how fast that wheel turns to the car's ABS. It is engineered specifically for Mazda vehicles.
- Synthetic material made to withstand harsh operating conditions
- Sealed connector that protects the plug in harsh conditions
- Tested on vehicles for correct integration with electronic safety systems
- Engineered for precision performance and a long service life
Quick facts
- Part: Standard Ignition ALS933 ABS wheel speed sensor
- Fits: 1988-1992 Mazda 626 and other vehicles
- Position: Rear right
- Material: Synthetic material
A lit ABS warning light, or a wheel speed signal that drops out, can point to a failing wheel speed sensor. Before you replace this one, rule out a damaged harness, a loose connector or debris at the sensor tip, since any of them can trigger the light too. One sensor sits on each side of the rear axle; this listing is the right one, and the rear left is ordered separately.
Fits
This sensor fits the 1988-1992 Mazda 626 and the 1988-1992 Mazda MX-6.
Specifications
Fit and size
- Position: Rear right
- Mounting location: Wheel
- Quantity per vehicle: 1 for this position
- Bolt holes: 4
- Harness length: 1250 mm (49 in)
- Connector: 1 rectangular, male
- Terminals: 2 female blade
Build and materials
- Material: Synthetic
- Connector: Sealed
- Country of origin: Japan
In the box
One rear right ABS wheel speed sensor. Mounting hardware is not included, so plan on new bolts rather than reusing the old ones.
Installation notes
- Grommets and wire clips are already on the harness for mounting and routing, which saves installation time.
Interchange: ABS1043 · ABSC20698 · 531524 · G2384371Y
This part cross-references / interchanges with the following part numbers:
ABS1043, ABSC20698, 531524, G2384371Y, ALS933
Frequently Asked Questions
Does the Standard Ignition ALS933 fit the 1988-1992 Mazda MX-6?
Yes. Standard Ignition ALS933 is a rear right sensor and fits the 1988-1992 Mazda MX-6 as well as the 1988-1992 Mazda 626. The left side is a separate part.
Is this Standard Ignition ABS wheel speed sensor for one wheel or the whole axle?
It is for one wheel only. This single sensor goes on the rear right, and the rear left needs its own sensor.
Does the ALS933 come with mounting bolts?
No. Standard Ignition ALS933 does not include mounting hardware, though the harness carries grommets and wire clips for mounting and routing.
How long is the harness on this ABS sensor?
The harness is 1250 mm (49 in) long. It ends in one rectangular male connector with two female blade terminals.
Can a lit ABS light mean a bad wheel speed sensor?
Yes, it can be one sign, though other faults can light it too. A shop can read the ABS codes to see which wheel's sensor is reporting a fault.
