Standard Ignition Accelerator Pedal Sensor P/N:APS253
$192.99
(You save)
Keep your throttle input reading true with the Standard Ignition Accelerator Pedal Sensor APS253. This accelerator pedal position sensor drops in as a direct-fit replacement for the 2005-2013 Chevrolet Corvette [All], translating how far you press the pedal into an electrical signal the engine control module uses to command the electronic throttle.
Function: Senses accelerator pedal position and sends the corresponding signal to the electronic throttle control system.
Direct-fit application: A direct-fit replacement for the accelerator pedal sensor on the listed Corvette applications.
Standard Ignition build: Supplied by Standard Ignition under part number APS253.
The accelerator pedal position sensor is the driver's link to a drive-by-wire throttle: there is no mechanical cable, so the module relies on this signal to open the throttle. A failing pedal sensor may show up as hesitation, erratic throttle response, reduced-power or limp-home mode, or an illuminated check engine light. Because those signs can have other causes, diagnose the fault first; if the original pedal sensor is confirmed faulty, this APS253 replaces it.
Interchange: Manufacturer part number APS253.
Frequently Asked Questions
What does this part do?
It senses how far the accelerator pedal is pressed and sends that signal to the engine control module, which commands the electronic (drive-by-wire) throttle.
Will this fit my vehicle?
It is a direct-fit replacement for the 2005-2013 Chevrolet Corvette [All]. Confirm your specific vehicle in the Buyer's Guide tab before ordering.
What is the manufacturer part number?
This is Standard Ignition part number APS253, an accelerator pedal position sensor.
What are signs this sensor may need replacing?
Possible signs include throttle hesitation, erratic response, reduced-power or limp-home mode, or a check engine light. Diagnose the cause first, since other faults can produce these symptoms.
Will replacing this fix my reduced-power condition?
If the original pedal sensor is confirmed to be the cause, installing this APS253 replaces it. Other components can trigger the same condition, so verify the fault before replacing.
Write a Review
STANDARD MOTOR PRODUCTS
Standard Ignition Accelerator Pedal Sensor P/N:APS253
Accelerator Pedal SensorAs a global manufacturer, we maintain complete quality control throughout the manufacturing processDesigned to maintain specific installed outputs to match OE rather than...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
