Standard Ignition Accelerator Pedal Sensor P/N:APS509
$457.99
(You save)
Give your drive-by-wire throttle a clean, accurate command signal with the Standard Ignition Accelerator Pedal Sensor APS509. It installs as a direct-fit replacement for the 2013-2018 Hyundai Santa Fe Sport, 2016-2018 Hyundai Santa Fe XL, the 2018 Hyundai Santa Fe, and the 2014 Kia Sorento, reading how far you press the pedal and relaying that position to the engine control module so it can set throttle opening.
Core job: Converts accelerator pedal position into an electrical signal the ECM/PCM uses to determine driver throttle demand in an electronic throttle system.
Direct replacement: Serves as a replacement pedal position sensor for the listed applications.
Signs it may need replacing: If a faulty pedal sensor is the cause, watch for erratic or hesitant throttle response, reduced-power/limp-mode behavior, or a pedal-position trouble code and check engine light.
Because these symptoms can also stem from wiring, the throttle body, or the ECM, diagnose the cause before replacing.
Interchange: PPS1409 · SU16091 · 2-80409 · 280409 · 327004Z000 · Manufacturer part number APS509
This part cross-references / interchanges with the following part numbers:
PPS1409, SU16091, 2-80409, 327004Z000, APS509
Frequently Asked Questions
What does this sensor do?
It reads how far the accelerator pedal is pressed and sends that position as an electrical signal to the engine control module, which sets throttle opening in the electronic throttle system.
Which vehicles does APS509 fit?
It's a direct-fit for the 2013-2018 Hyundai Santa Fe Sport, 2016-2018 Hyundai Santa Fe XL, 2018 Hyundai Santa Fe, and 2014 Kia Sorento. Confirm fitment for your vehicle.
What part numbers does it interchange with?
It replaces PPS1409, SU16091, 2-80409 (280409), and 327004Z000. Its own manufacturer part number is APS509.
What are signs this sensor may need replacing?
Erratic or hesitant throttle response, reduced-power or limp-mode behavior, and pedal-position trouble codes with a check engine light can point to it, if the sensor is the cause.
Should I diagnose before replacing?
Yes. These symptoms can also come from wiring, the throttle body, or the ECM, so verify the pedal sensor is the cause before replacing it.
Write a Review
STANDARD MOTOR PRODUCTS
Standard Ignition Accelerator Pedal Sensor P/N:APS509
Accelerator Pedal SensorAs a global manufacturer, we maintain complete quality control throughout the manufacturing processDesigned to maintain specific installed outputs to match OE rather than...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
