Standard Ignition Accelerator Pedal Sensor P/N:APS620

Be the first to review this product
$228.99
MPN: APS620
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Standard Ignition Accelerator Pedal Sensor P/N:APS620
Standard Ignition Accelerator Pedal Sensor P/N:APS620
$228.99

Keep your drive-by-wire throttle reading pedal input accurately with the Standard Ignition Accelerator Pedal Sensor APS620. It drops in as a direct-fit OE replacement for the 2012-2013 Chrysler 300 (All engines), and because the pedal assembly is included, you replace the sensor and pedal together in one swap. An accelerator pedal sensor converts how far you press the pedal into the electronic signal the engine computer uses to command throttle position; if a failed sensor is the cause of erratic throttle behavior, this unit replaces it.

  • Built with full quality control: produced under complete quality oversight across the manufacturing process.
  • OE-matched output: designed to hold specific installed outputs to match OE, rather than relying on adjustable consolidated designs.
  • Direct-fit OE replacement: restores proper accelerator pedal sensor function without modification.
  • End-of-line tested: validated with thousands of data points to confirm output voltages for dependable operation.

This new unit features plastic construction with a bolt-on attachment and a single rectangular, female plug-in connector carrying six male terminals. Mounting hardware and mounting brackets are not included, and no linkage is attached — consult the vehicle service information for the correct fasteners and whether they may be reused. Made in the United States.

Interchange: Manufacturer part number APS620.

This part cross-references / interchanges with the following part numbers:

PPS1520, 4581661AA, PPSB10255, 2-80520

Frequently Asked Questions

What does the APS620 accelerator pedal sensor do?

It converts how far you press the accelerator pedal into an electronic signal the engine computer uses to command throttle position in a drive-by-wire system.

Does this include the accelerator pedal assembly?

Yes. Per the catalog, the pedal assembly is included, so you replace the sensor and pedal together as one unit.

Will this fit my vehicle?

It is a direct-fit OE replacement for the 2012-2013 Chrysler 300 (All engines). Check the Buyer's Guide tab to confirm fitment for your vehicle.

Are mounting hardware and brackets included?

No. Mounting hardware and mounting brackets are not included, and no linkage is attached. Consult the service information for the correct fasteners and whether they may be reused.

What are signs this sensor may need replacing?

Signs may include erratic throttle response, reduced power or a related pedal-position warning light. Diagnose the cause first, since these symptoms can have other sources.