Standard Ignition BSD128 blind spot detection system warning sensor for the 2019-2020 Ford Ranger and other vehicles watches the lane beside the vehicle for traffic. It supplies the signal the blind spot warning system uses to alert the driver.
- Built to stringent quality standards
- Components and materials made to withstand harsh engine conditions for longer service life
- Extensive testing and validation for proper performance and reliability
- Single female plug-in connector with 8 male pin terminals
Quick facts
- Part: Standard Ignition BSD128 blind spot detection system warning sensor
- Fits: 2019-2020 Ford Ranger and other vehicles
A blind spot warning light that stays lit, a system fault message or alerts that seem missing or false can come from this sensor or from something else in the system. With the engine off, look over the sensor housing and its connector for damage, a loose plug or corrosion before you replace the sensor.
Fits
This blind spot detection system warning sensor is a direct-fit OE replacement for the 2019-2020 Ford Ranger, the 2020 Ford Transit-150 and the 2020 Ford Transit-250, with two sensors per vehicle. This listing is one sensor. If your Ford is not named here, open the "Vehicles it fits" section to check your exact model, year and engine.
Specifications
- Quantity per vehicle: 2
- Connector quantity: 1
- Connector type: plug in, female
- Terminal quantity: 8
- Terminal type: pin, male
- Country of origin: United States
Interchange: 861-116
BSN128 · BDSA3 · BSW132 · KB3Z14C689B
This part cross-references / interchanges with the following part numbers:
BSN128, BDSA3, BSW132, KB3Z14C689B, 861-116
Frequently Asked Questions
Does the Standard Ignition BSD128 fit the 2020 Ford Transit-150?
Yes. Standard Ignition BSD128 fits the 2020 Ford Transit-150, which takes two sensors. For other Ford models, open the "Vehicles it fits" section.
What connector does this blind spot detection system warning sensor have?
This sensor has one female plug-in connector with 8 male pin terminals.
Is Ford KB3Z14C689B a cross-reference for the Standard Ignition BSD128?
Yes. KB3Z14C689B is listed as an interchange number for Standard Ignition BSD128, so this sensor replaces it. The other cross-reference numbers are on the Interchange line.
Is this blind spot detection system warning sensor tested for performance and reliability?
Yes. The sensor goes through extensive testing and validation for proper performance and reliability.
How can I tell if my blind spot warning sensor is going bad?
A warning light that stays on, a system fault message, or missing or false alerts can mean a sensor problem, though other causes are possible. A shop can test the system.
