Standard Ignition Distributor Cap P/N:JH-70
Keep spark reaching every cylinder in the correct firing order with the Standard Ignition Distributor Cap JH-65, a direct-fit replacement for the 1971-1973 Dodge Colt. Seated on top of the distributor, the cap carries high-voltage current from the ignition coil and, as the rotor turns beneath it, hands that spark off to each spark plug wire in sequence.
Interchange: C553 · 1235999201 · MD602081 · JA922 · EP320 · 12302967 · DC78
Manufacturer part number JH-65 (also JH65).
This part cross-references / interchanges with the following part numbers:
What does a distributor cap do?
It sits on top of the distributor and routes high-voltage current from the ignition coil, through the rotor, out to each spark plug wire in the engine's firing order.
Which vehicles does the JH-65 fit?
It is a direct-fit replacement for the 1971-1973 Dodge Colt. Check the Buyer's Guide tab to confirm the fit for your specific vehicle.
What are the signs of a failing distributor cap?
Cracks, carbon tracking, or corroded terminals can cause misfires, rough running, or hard starting. If a worn cap is the cause, replacing it addresses those symptoms.
What numbers does this cap interchange with?
It cross-references C553, 1235999201, MD602081, JA922, EP320, 12302967, and DC78. The manufacturer part number is JH-65.
Should I inspect anything else when replacing the cap?
It is good practice to inspect the rotor and spark plug wires at the same time, since they work together to deliver spark. Diagnose the cause of any misfire before replacing parts.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.